View Full Version : right rear panel re-install
ojmagg
05/16/2003, 07:21 AM
I was wondering if anyone who has removed the front-most plastic panel behind the dirver's seat had any problems re-installing. I can get all the clips in except the one closest to the jack. All the clips are new. Now, the plastic sits out about an inch and is no longer flush. I trimed the insulation and dynamat so all mounts and clearances are good...?
iownvx
09/21/2003, 11:17 PM
Hi,
Where did you get the new panel retainers? What's the part number?
Navigator
09/22/2003, 05:31 AM
Use the clips that look like plastic feathers instead. they will star to grip regarless of the differnt fit dynacis dynamat will cause, and this will make your cladding sit flush.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.