having trouble removing axle, the cv shaft is locked in the differential housing, it should have a circlip that will remove it, by poping it out of the bore spline clip locator, (slot), broke a tool in the process of failure, thinking the clip crossed the spline on installation, and locked from forcing it in, any suggestions? 1999 ironman model, joe.
taylorRichie
06/26/2008, 05:52 PM
http://www.vehicross.info/forums/showthread.php?threadid=9031
Maybe that'll help, welcome to the forums.
Greasemonkey
06/27/2008, 06:15 AM
Hi these are very tight - you just need a bigger lever bar - try to make the levering action even by using two bars opposite - you can take the cv joint to bits if required and use a slide hammer hooked into the remaining section but its alot of mess
cheers
Steve
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.