View Full Version : Need clarification regarding disabled TOD
phines
10/07/2008, 08:09 PM
Okay VX gurus, I need to get this cleared up and I'm hoping one of you will have the answer. If I disable the TOD and have manual hubs, will the front drive shaft/axle still turn? I keep seeing and hearing mixed answers regarding this issue, but does anyone know for sure?
IF the drive shaft and axle are NOT completely disengaged, is there a way to do that without physically disconnecting it?
Thanks for any info you guys can give me. I really appreciate it!
________
Sick from nexium (http://www.classactionsettlements.org/lawsuit/nexium/)
Okay VX gurus, I need to get this cleared up and I'm hoping one of you will have the answer. If I disable the TOD and have manual hubs, will the front drive shaft/axle still turn? I keep seeing and hearing mixed answers regarding this issue, but does anyone know for sure?
IF the drive shaft and axle are NOT completely disengaged, is there a way to do that without physically disconnecting it?
Thanks for any info you guys can give me. I really appreciate it!
Paul, I am not sure what you mean by "If I disable the TOD" .
But having had manual hubs on all my previous 4wds, I will give the following answer -
For a standard 4wd where you can select 2wd high, when you set manual hubs to the "unlock" position, your wheels will turn without the drive train turning. So, as you drive, the cv's, front diff, and front tailshaft do not turn. This saves wear and tear, and improves fuel consumption because there is less friction loss.
The above also applies to the JDM VX with the 2H position (as per my VX).
For the USA VX with constant TOD, you can still fit the manual hubs, and in the "unlock" position they will disconnect the wheels from the drive train. However, as you drive along the front drive train will still turn as it is fed from the TOD. It just will be doing nothing to help propell the vehicle.
This will still help in reducing wear and tear, as there is no load on the front drive train. It will also give you a slight saving in fuel economy, but not as much as I enjoy.
The bad point is that if you get into trouble, you only have the rear wheels driving until you get out of the car and "lock" the hubs. If you hit a sudden patch of ice and snow, you may not have this opportunity before the other half of the accident scene reaches you.
Short answer is that to have best effect with manual hubs, you have to find a way to switch off your TOD, and there are several threads you can search here for that.
The other big advantage with manual hubs, is eliminating the sledging when doing a tight turn in a car park etc.
PK
VehiGAZ
10/08/2008, 08:14 AM
Yeah, what do you mean by "disabled"? If you pulled the ToD fuse, I am pretty sure that it leaves the ToD clutch pack open. When my ToD system was out last spring (due to shorted wires and a blown ToD fuse) I seemed to have no power going to the front axle, but I cannot say that I proved it one way or another.
The most reliable answer will come when you pull the fuse, unlock the front hubs, lift the thing off the ground at a tire shop (that is, on a lift that leaves the wheels free), and see if the fronts spin when you put it in gear.
deermagnet
10/08/2008, 06:22 PM
VehiGAZ, where is this TOD fuse you speak of? I did a search here and the existence of a TOD fuse has been questioned many times, but the location is never confirmed. I looked in the factory manual and there is no mention of a TOD fuse in the TOD diagnostic/troubleshooting procedures. There is no TOD fuse shown in the underhood fuse box diagram. The ABS is related to the TOD, but when the ABS fuse is pulled TOD still works fine.
Thanks, Mark
VehiGAZ
10/09/2008, 06:33 AM
Huh - good question. I thought it was in the box under the hood. Is it on the ToD controller itself maybe? I was told the fuse was blown by the dealership, and while they've never BS'd me before, there's no telling.
I have a spare ToD at home - I'll check that for a fuse and report back.
phines
10/09/2008, 08:07 AM
Paul, I am not sure what you mean by "If I disable the TOD" .
PK
I was just referring to the modification that others have done- installing a switch to turn the TOD off/on.
Thanks for the info guys. Nazrat cleared things up for me over in the planetisuzoo forum too. I guess I know what I'll be doing this weekend! :bgwo:
________
Shemale mistress (http://www.****tube.com/categories/969/mistress/videos/1)
Triathlete
07/08/2010, 02:56 PM
Since the ????was never answered....where is the TOD fuse located?
Triathlete
07/08/2010, 03:08 PM
Never mind...did a bit more extensive search and found this...
ToD system fuse under the hood. Behind the battery (meaning, toward the firewall from the battery) is a fuse box. Check the fuses there.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.