PDA

View Full Version : Removing roof rail covers


JAMAS
08/05/2009, 07:26 AM
How do you do it without breaking them?
Scott Harness
08/05/2009, 07:29 AM
VERY CAREFULLY! I use a flathead screwdriver and gently pry the tabs away from the rail.
JAMAS
08/05/2009, 07:33 AM
VERY CAREFULLY! I use a flathead screwdriver and gently pry the tabs away from the rail.

From the side facing outward, or inward?
Scott Harness
08/05/2009, 07:35 AM
There are tabs on both sides,but I think it's easier to start on the inside.
JAMAS
08/05/2009, 07:36 AM
There are tabs on both sides,but I think it's easier to start on the inside.

Alright. Thanks!

Wish me luck, I think I will try it this evening.
Scott Harness
08/05/2009, 07:36 AM
The covers are shorter on the inside
TheGanzman
08/05/2009, 09:24 AM
The way I do it is to stand on each side, slip my fingernails carefully under the inboard edges, and carefully "lift" it up and out...
nfpgasmask
08/05/2009, 09:46 AM
Yeah, they are TIGHT. I snapped one tab on one of mine when removing. Just go real slow and be careful.

Bart
MSHardeman
08/05/2009, 09:52 AM
I have the rail covers off of mine and can snap a picture of them so you can see where the tabs are if you would like.
JAMAS
08/05/2009, 10:08 AM
I have the rail covers off of mine and can snap a picture of them so you can see where the tabs are if you would like.

if you dont mind....

That would be AWESOME!
don moore
08/05/2009, 10:34 AM
some one was thinking ..hmmmm this idea should work.. we will put tabs on them and slide them on till they snap on..........oops we didnt think anyone would want to remove them.
MSHardeman
08/05/2009, 11:52 AM
JAMAS, here are a few pictures for you.

http://www.vehicross.info/gallery/data/500/Roof_Rail_01.JPG
This one is tough to see, but it's the outside of the roof rail. Notice the notches at the front and back, that's where the tabs on the rail covers snap in.

http://www.vehicross.info/gallery/data/500/Roof_Rail_02.JPG
This is the back side of the roof rail. Again, notice the slots for the cover tabs.

http://www.vehicross.info/gallery/data/500/Rail_Covers_02.JPG
Back side of all four rail covers. All of the tabs are perpendicular to the surface of the covers.

http://www.vehicross.info/gallery/data/500/Rail_Covers_03.JPG
Cover Close-up.

I think, like others suggested, you have to wedge a screwdriver, or your fingers, under the bottom outside edge of the rail cover and gently pull away from the rail so that the tabs on the covers clear the slots in the rail. Then you can rotate the cover up until it comes off.

Hope this helps.
JAMAS
08/05/2009, 12:01 PM
Thanks alot for the pictures. That will help alot.

Hopefully I am not on here tomorrow looking for replacements.
JHarris1385
08/05/2009, 12:21 PM
Just removed some last week....the easiest way is to flat head from the outside and twist the screw driver very little and they pop off. From the back and the angle creates pressure on the front and the tabs are more prone to break.
JAMAS
08/06/2009, 05:30 AM
SUCCESS!!!!!