PDA

View Full Version : Check Engine Light



tomdietrying
04/13/2010, 06:16 AM
My check engine light came on as I was driving to work. I'm going to take it to Pep Boys after work to see if they can tell me the code number. In the mean time, Does anyone have aguess at what they think it may be? BTW my VX has 111,000 miles on it.
Peace.
Tom

vt_maverick
04/13/2010, 06:21 AM
Hold on I'm spinning my magic 8-ball right now... :p

vt_maverick
04/13/2010, 06:22 AM
It says "Consult me later when you have symptoms." ;)

Ldub
04/13/2010, 06:50 AM
Gotta be wheel adaptors...:smilewink...:laughing:

WormGod
04/13/2010, 06:59 AM
Gotta be wheel adaptors...:smilewink...:laughing:

Wheel spacers rocked out your camber didn't they? :p

http://i106.photobucket.com/albums/m255/MX5_Dorifto/camber.jpg

samneil2000
04/13/2010, 07:03 AM
Oh man, there are no words to describe that monstrosity...

OT, low oil? haha

Bee Sting
04/13/2010, 07:26 AM
Had CEL being a pain a little while ago.

If PepBoys tells you that it is a P0440 start by asking them to reset it and then crank your gas cap on and see if it comes back.

Upon inspection I noticed that my gas cap was missing one of the white tabs on the inside. I ordered a new one from Merlin and have only had the light come on once in the last 4 months and after getting some gas and cap cranking it went out without a code reset.

tom4bren
04/13/2010, 08:10 AM
The only CEL I've ever gotten in the VX was from a dirty MAF sensor.

nfpgasmask
04/13/2010, 09:47 AM
Tom, I'm gonna roll the dice and offer a real suggesstion.

I say it's your EGR!

What do I win if I get it right?

:) Bart

Dumke
04/13/2010, 09:56 AM
Tom I agree with Bart. I get p1404 code alot and just reset it.

Scangauge II is your friend and easier alot of my worries. Going on 140k myself. If you havent cleaned your EGR then I am guessing its that.

phines
04/13/2010, 09:59 AM
I'm betting on an O2 sensor. And not necessarily a bad sensor, just a bad connection. They will try to sell you the sensor though...

I may have experienced this once or twice. :)
________
Hotels In Mexico (http://mexicohoteles.org)

nfpgasmask
04/13/2010, 10:27 AM
If it is EGR, you could clean it or spend the $100 or so on a new one. I always opt for new. And this is very easy to do in your garage. Take off old, put on new, clear codes, drive away!!

I say EGR because when mine did this, I did not have any symptoms (no rough driving, etc). An O2 sensor could be it too, but usually if it is a bad O2 sensor you will get some symptoms.

Just my .02.

Bart

Triathlete
04/13/2010, 11:00 AM
Until you get the code read it is just aguessing crapshoot. There are litterally thousands of things it could be. However 90% of the time a steady CEL comes on it is emissions related...sensors, MAF, EGR, etc..........

RamAirZ
04/13/2010, 11:32 AM
I say your muffler bearing went out. I had this happen to me not too long ago, fairly easy to replace, or it could just need greased.

http://kalecoauto.com/images/MuffBearing.jpg

Now I don't know if you have done it, but switching over to synthetic blinker fluid might be a good idea too, that has made my light come on before

http://kalecoauto.com/images/BlinkFluid.jpg



just joking around hehe

Mile High VX
04/13/2010, 11:36 AM
LMAO...:yes:

RamAirZ
04/13/2010, 12:06 PM
That company also offer's such products as:

The Butt Dyno:
http://kalecoauto.com/images/buttdyno.jpg

The patented lowering kit for all vehicles:
http://kalecoauto.com/images/LowerKit.jpg

These are awesome, polishing pads with wear indicators, now you know when you need to replace them!:
http://kalecoauto.com/images/polishpads.jpg

The adjustable power band:
http://kalecoauto.com/images/powerband.jpg

and for our lady drivers, an automatic tampon dispenser!

"This is dedicated to the lady racer on the go! Featuring quick dispensing action, the Tampon Dispenser for Automatic Vehicles is the ideal match for any vehicle with an automatic transmission. The built in canister operates much like the clip of a gun, and has a capacity of 12. Extended clips may be purchased, depending on vehicle. Absolutely not for use with manual transmissions!
Deep Discount for Hyundai Tiburon owners!"

http://kalecoauto.com/images/tampon.jpg

tomdietrying
04/13/2010, 04:22 PM
Pep Boys' scanner is not working. I'll try to find another Pep Boys by my house tomorrow.
Peace.
Tom

Dumke
04/13/2010, 04:38 PM
Tom if I am not mistaken any autoparts store should have a reader.

RamAirZ
04/13/2010, 05:12 PM
I don't know about Texas, but California won't let the autoparts stores do free code reading anymore, it's stupid. If you were closer I have a laptop program with hookups I could check it for you. Let us know what you find!

tomdietrying
04/14/2010, 03:19 PM
I went by Coppell Tire and Service, and they did it for me. The code that came up was P1441 evap system blow during non-surge. Anyhow, it has to do with some emission coming from the tank. It might be a loose the gas cap.

Anyhow, they reset the Check Engine light. I then had a great idea. I'll go get my inspection sticker while the light is not on. Turns out when you reset the engine light the emission check comes back as Not Ready. Apparently, it takes a couple of days to read the engine and the emissions. It didn't pass.

I have to go back on Friday to see if its calculating everything and then see if it passes. I have a feeling it will.

Peace.
Tom

Dumke
04/14/2010, 03:50 PM
That or move to a county that doesnt check emmisons... Thank goodness for having car registered in the boonie :D


Hopefully it wont be much to fix Tom. Thanks for reminding me to get mine inspected before Moab :)


I went by Coppell Tire and Service, and they did it for me. The code that came up was 14143 or 1443. Anyhow, it has to do with some emission coming from the tank. It maybe the gas cap.

Anyhow, they reset the Check Engine light. I then had a great idea. I'll go get my inspection sticker while the light is not on. Turns out when you reset the engine light the emission check comes back as Not Ready. Apparently, it takes a couple of days to read the engine and the emissions. It didn't pass.
I have to go back on Friday to see if its calculating everything and then see if it passes. I have a feeling it will.

Peace.
Tom

RamAirZ
04/14/2010, 04:24 PM
That's why I can't wait to get to florida, no inspections what so ever lol

Triathlete
04/14/2010, 06:26 PM
I don't know about Texas, but California won't let the autoparts stores do free code reading anymore, it's stupid. If you were closer I have a laptop program with hookups I could check it for you. Let us know what you find!

In Az. they can read them but can't reset the code unless you buy the parts to fix it.

WormGod
04/15/2010, 07:00 AM
In Az. they can read them but can't reset the code unless you buy the parts to fix it.

And all over the world, a ScanGauge will do it for you. ;)

tomdietrying
04/17/2010, 07:06 AM
The check engine light never came back on. I took the VX back to the inspection place. There was no problem with emissions, and the inspection pasted easily. :yesy:
Peace.
Tom

RamAirZ
04/17/2010, 09:38 AM
awesome, congrats!