GPA
08/12/2013, 01:35 PM
When I got my VX a few weeks ago, I noticed the wipers looked "out of whack!"
They were not sitting parallel (or even close to parallel) to the ground, and I noticed they did not seem to cover the windshield as they should when they were in operation.
So....I did some research....checked for the proper sizes, which I found out were: 24" Driver Side and 17" Pass Side.
I measured, and sure enough, I had a 24" and 17" on the VX. Only problem was they were reversed! (17" was on Driver Side; 24" on Pass Side).
I went and bought a brand now 24 & 17 Rain X and put them on the proper sides.
Problem solved! Right?? Not so fast!
They still looked funny; couldn't get them parallel; and the Driver Side would now extend way above the top molding of the windshield when in operation.
WTH is going on here?? :_confused
So....thought about it a bit and decided to measure the WIPER ARMS to see if they were different lengths.
Sure enough!
Discovered the Shorter Arm needs to go on the Driver Side with the Longer Blade.
The Longer Arm should go on the Pass Side with the Shorter Blade.
Mine were reversed, likely because someone took them off in the past and thought it didn't matter which arm went on which side.
Now....Problem Solved!:thumbup:
I wanted to share this because when I searched the forum, I discovered a lot of posts with different size blades, ill-fitting blades, poor coverage, etc.
So....if your wipers aren't covering like they should, be sure to check that you have the Shorter Arm and Longer Blade on the Driver Side, and the Longer Arm and Shorter Blade on the Pass Side!
Mine are working great and covering like they should now!
GPA
They were not sitting parallel (or even close to parallel) to the ground, and I noticed they did not seem to cover the windshield as they should when they were in operation.
So....I did some research....checked for the proper sizes, which I found out were: 24" Driver Side and 17" Pass Side.
I measured, and sure enough, I had a 24" and 17" on the VX. Only problem was they were reversed! (17" was on Driver Side; 24" on Pass Side).
I went and bought a brand now 24 & 17 Rain X and put them on the proper sides.
Problem solved! Right?? Not so fast!
They still looked funny; couldn't get them parallel; and the Driver Side would now extend way above the top molding of the windshield when in operation.
WTH is going on here?? :_confused
So....thought about it a bit and decided to measure the WIPER ARMS to see if they were different lengths.
Sure enough!
Discovered the Shorter Arm needs to go on the Driver Side with the Longer Blade.
The Longer Arm should go on the Pass Side with the Shorter Blade.
Mine were reversed, likely because someone took them off in the past and thought it didn't matter which arm went on which side.
Now....Problem Solved!:thumbup:
I wanted to share this because when I searched the forum, I discovered a lot of posts with different size blades, ill-fitting blades, poor coverage, etc.
So....if your wipers aren't covering like they should, be sure to check that you have the Shorter Arm and Longer Blade on the Driver Side, and the Longer Arm and Shorter Blade on the Pass Side!
Mine are working great and covering like they should now!
GPA