will this wheel size fit?

[Bagheera]

Just wondering about this wheel size for my VX?

Size: 20" X 9.5"
Bolt Pattern: 6 X 5.5/139.7mm
Offset: 10mm

thanks guys/girls ;)

~K

[Daver]

The bolt pattern is fine, but that's a wide wheel. Gonna stick out from the fenders almost 2.5" more than the stock wheels.

Whether it'll fit or not really depends on the tires you choose.

-Daver

[Bagheera]

Hey Daver!

Thanks for your reply :D

Do you have any idea of the size of our stock 16" rims?

What size tires would you recommend for the 20" x 9.5" ....the less they stick outside the fender the better.

Thanks again,
~Kiersten;py;

[coachreed]

Are you looking at a particular wheel? Be sure that it is compatible with the VX's hub... that bolt pattern is the same as most full size chevy/GMC trucks too... but they won't all fit due to the larger hub's on foriegn vehicles like the VX... at one point I was eyeballing a set of Weld EVO wheels but turns out that the hub wasn't compatable... soo... check to make sure... if you don't know for sure, try to buy from a reputable, local dealer that will test fit them... just an idea.

TTYL!

Coach... I mean Randy (I often forget who I really am) ;)
http://www.vehicross.info/gallery/data/500/406banner.jpg (http://www.geocities.com/ironmanvx2000)
Undergoing LS1 Conversion as we speak!
Click Image to Visit My Website!

[Bagheera]

Hey Randy :D

check ur PM

~K

[WormGod]

I have an 18x8.5 with a 0 offset and they still stick out a good 1". In my opinion, it doesnt look too bad at all, but my state law says no no. As far as just looks though, 1" seems like the furthest I would go on it, unless I lifted it up and stuck some big old 38"s under there. ;) A 9.5 sounds rather heavy for the VX and will surely cause handling changes in your ride. Without a lift, you will surely be doing some heavy trimming too, and I mean HEAVY.

Stock lift with Enkei 18x8.5s and Yokohama AVS 285x60s.

http://wormgod.8m.com/Images/Ebony/vx10.JPG

Good luck on your new shoe endeavor.

[Bagheera]

Yeah.....that looks WICKED!

I'd say 1" is about the most I'd like the wheels to stick out....What make of wheels/tires are those WormGod?

I decided against the 20" x 9.5" after all the info from you guys :D

I'll probably go for the same wheel in a 20" x 8.5" with a 6 offset.....but what makes the wheels/tires stick out so far? Is it the offset or the 8.5 measurement?

Thanks again guys !

~Kiersten