PDA

View Full Version : Dropping front drive shaft



AlaskaVX
06/03/2004, 01:48 PM
Is there oil or grease or anything that I will need to replace once I drop it? I am planning on doing it this weekend before I go to the track. I have installed the TOD switch, but still haven't found the correct resistance to make it work on the fly.

Thanks,
Alan

BBVX
06/03/2004, 04:35 PM
dropping it as in dropping it 2 inches

or

dropping it as in removing it completely??

azskyrider
06/03/2004, 08:13 PM
Alaska,

Any word on the your friends VX SAS conversion? He was suppose to begin the project in April right?

AlaskaVX
06/04/2004, 11:29 AM
Removing it temporarily for the drags.
As for the SAS his landlord jacked up his rent and he has been real busy finding another place. Will probobaly take a while.

SPAZZ
06/04/2004, 12:25 PM
no oil or grease to replace....unless you loosen pinion nut....but, if you do not loosen front pinion nut it is easy and doesn't take long...only rear front drive shaft bolts are a real biyatch to get off...be real careful not to damage the flange..but a flat screwdriver and hammer/mallet does the job...just be persistant..

have to shift in and out of 4 low and neutral to move and lock drive shaft where needed to loosen bolts...