View Full Version : EGR Valve Cleaning
kpaske
12/04/2004, 08:36 PM
In case anyone is interested, I noticed there wasn't a good EGR Valve cleaning HOW TO out there, so I made one and posted it to my web site. There also wasn't an illustrated Fuel Filter replacement HOW TO (though there were a few good non-illustrated ones), so I made that one too. If anyone cares to take a look, and offer any suggestions if I left out anything important, I'd be happy to update them.
EGR Valve Cleaning HOW TO (http://kpaske.shacknet.nu/public/EGR.htm)
Fuel Filter Replacement HOW TO (http://kpaske.shacknet.nu/public/fuelfilter.htm)
johnnyapollo
12/05/2004, 06:33 AM
Most Excellent.
-- John
Heraclid
12/05/2004, 09:04 AM
Thanks!
Chopper
12/05/2004, 10:06 AM
Wonderful!!
dkmiller68
12/05/2004, 12:00 PM
Great job and thanks...What are the symptoms that the ERG is in need of cleaning? Bad idling, acceleration, an error code perhaps?
Kahuna
12/05/2004, 12:09 PM
It's people like you that make this forum so valuable. Thanks for the work!!!:thumbup:
VehiCrazy
12/06/2004, 07:13 AM
BTT
I'm with dkmiller68. What are the signs of failure?
kpaske
12/06/2004, 04:59 PM
If it gets clogged enough it will set off an error code / check engine light and can cause rough idling. Some have even claimed that it can cause engine failure, but that is questionable.
If the nut becomes loose, it will cause a diesel exhaust or clicking sound from underneath the hood.
After giving mine a thorough cleaning I felt as though my VX ran and idled a bit smoother. The improvement was minor, but worth the 10 minutes it took.
VehiCrazy
12/07/2004, 07:41 AM
Thanks for the info, that is a great how-to page.
;Db;
raider
12/07/2004, 02:52 PM
Thanks kpaske.
Also, NAPA sells a replacement gasket with a screen in place for the valve hole (large hole), about $10.00. This helps with breaking up the carbon as it passes through. Helping to keep the carbon from building up in the egr.
I had this problem with my S-10 SS. It caused the engine to stall at idle and under load on the highway. Got so bad the truck wouldn't run. Took off the egr and cleaned it real good/replaced the gasket with the NAPA one and it has run just fine since.
cascabel3
12/07/2004, 04:18 PM
Nice work on both pieces. I'll be in my garage this weekend. Thanks
virtualruffy
11/10/2022, 06:52 AM
Dead links. If anyone can repost.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.