so how did you remove the recline knob???? been looking at doing this myself......
so how did you remove the recline knob???? been looking at doing this myself......
The thing pops right off. I took two flat heads and put one on opposite sides of the knob then twisted them and it popped right off.
I finished the write-up today and have all the pics taken. Tomorrow I'm putting it all together then posting it.
I can't wait to see your writeup! This sounds like a fairly inexpensive, worthwhile mod for those of us in the cooler climates.
So how difficult would it be to remove the leather completely for reconditioning or replacement?
Calmini Cone Air Filter, PowerVault PV2 Muffler, OME Trooper Springs, Rancho RS9000X Shocks, 285/75R16 Nitto Grappler AT's, Pioneer DEH P8000R In-Dash CD, Amps and Drivers Built by Orion, Wires and Fuse Blocks by KnuKonceptz, Vibration Damping by BQuiet, Alarm System featuring Auto Start and Remote Windows, Yakima LoadWarrior w/Full Size Spare, Debadged/Custom Titanium Grill Logo, Tint (5% Rear / 20% Front), Steel Braided Brake Lines, G2 Painted Calipers
http://www.mothermary.com/vx/recaro_...bly/index.html
It's really not difficult at all. Just time consuming. I'm not sure how to post this so it is immortalized. I can send the html + imgs to an op to post in the how-to section.
This should really be classified as a Recaro Trend Seat Disassembly How-To more than a Seat Heater install.
Let me know if anything needs clarification.