question to those with Alpine SC

[Ldub]

I'm currently not running the SC - took if off this previous spring due to the horrible drive bearing noise. In my case I previously purchased a complete intake manifold from an Isuzu Trooper - that way I could leave the fuel rails on most of the parts intact on the SC Alpine manifold. It's sitting in a box ready for shipping, unfortunately I got laid off 5 months ago so the SC is still sitting in a box. I put all my old gear back on my original manifold, using the fuel rails from the extra Trooper one - the intake port is actually a different size so it's not a direct swap. I left the tensioning plate on the front of the motor behind the pulley as I intend to eventually get the SC back on there.

I found someone locally who could do the job but never got a response when I called and left several messages. I'm not sure who I'll use at this point.

-- John

Since I noticed the link in Green Dragons post is dead, I did a little snooping.

I hope any of this will eventually lead to something useful to you...

http://www.thehighspeedlab.com/index.html

Check out all the offered services for Eaton blowers here...

http://www.thehighspeedlab.com/catalog.htm

Here's a "ballpark" HP calculator that's kinda fun to play with...

http://www.superchargersonline.com/hp_calculator.asp

Start at 215 crank HP, Plug in 20 lb boost, 108 octane & a 3 core intercooler, then let your mind wander...