question to those with Alpine SC

[ScottinMA]

Reiterating a question from my last post concerning the fuel pressure regulator, but with pictures this time to try to get my point made more clear. Basically, there is a protection bracket (so the workshop manual calls it) surrounding the regulator that houses a wire harness connection and 2 small ports.



(2 and 3 below point to the 2 ports on the protection bracket w/ wire harness port)



Besides getting the right length hosing to finish the install and figuring out where this bracket and these ports fit into the S/C equation, these are really the only things holding me back from finishing. Any out there that installed their own S/Cs got the answer I am looking for?

S/C installs were clearly more simplified on PRE fuel injected cars.

Dub,

Do you know whether you still have the reference hoses to these numbers? Would be so helpful if you did (example: fuel regulator vacuum to number 1 etc). Thanks