Headliner removal

[biju]

I hope to have it all done before Moab!

...you're in gooooood company, mang.

-biju.

[Kenny]

My $0.02 too.
In place of mechanical fastening, you might consider heavy duty velcro. It's a light piece of hardware, especially if your mount box is also plastic.

[nfpgasmask]

Thanks again fellas!

Bart

[rowhard]

Hey bart, is your top audio hole filled? this is what I did with my scan gauge - John

[rowhard]

There it goes again, only a thumbnail photo. wish I could figure this out. anyway, there is a big picture in my gallery, 'get the big picture now'

[nfpgasmask]

Putting it in a DIN would be ideal, but both of mine are already full. I am thinking about fixing the scan guage onto some ABS and putting that over the bottom DIN slot where I have my power inverter via some sort of little door. So all I have to do is lift up the door to get to the invertor.

But either way, I have to wait until I get it to start planning...

Thanks - Bart

Hey bart, is your top audio hole filled? this is what I did with my scan gauge - John

[rowhard]

another thought. Do you have and use the ash tray? It might fit there too. that might be a cool place for it,.... maybe

[nfpgasmask]

Yeah, my ash tray has the cig lighter cable for my power inverter coiled up in it, but maybe I could mount it on top...

We shall see. Nothing like a good mod challenge!

Bart

another thought. Do you have and use the ash tray? It might fit there too. that might be a cool place for it,.... maybe