Permanent Fix for the plastic window tabs

[Bulldoggie]

I tried the spacer fix.....still tilts slightly so im not happy.......LOL
i would like to see the inside of another VX (in Person)and see if it is wearing on the track the same as mine...just to much play in mine! Will get a chance next week to pull it apart again and pull the whole thing out to see what i can do about it...
Thanks Bulldoggie
Tim
www.streetboutiquecustoms.com

It is possible that the plastic guides on your lift arm track are worn beyond their porpose. most likely the one that has a thin slot that rides the edge of the track. (this is the one that controls vertical alignment) the other guide wraps around the other edge and holds the arm close to the track. You might pull the panel on the other door and compare the wear on the arm guides. I have no fix for these two plastic (nylon) guide pieces. If you cannot make your own, you may have to buy a complete regulator to get those pieces.

Sorry it's not a very good picture.

[SBC]

It is possible that the plastic guides on your lift arm track are worn beyond their porpose. most likely the one that has a thin slot that rides the edge of the track. (this is the one that controls vertical alignment) the other guide wraps around the other edge and holds the arm close to the track. You might pull the panel on the other door and compare the wear on the arm guides. I have no fix for these two plastic (nylon) guide pieces. If you cannot make your own, you may have to buy a complete regulator to get those pieces.

Sorry it's not a very good picture.

Yep same as mine to much play in that spot!.....Just gonna figure a way to fix that little problem of the guides by adding a roller to it or something like that......Just like with the clips I will build somthing rather then buying a replacement so i dont end up with the same problem a year or two down the road!
Tim
www.streetboutiquecustoms.com