I just installed a set of 285/60/R18 Toyo Proxes S/T. I trimmed the cladding a wee bit and everything seems OK so far -- no rubbing as far as I can tell. I'm glad, because I didn't even have to use the big freakin' hammer ("BFH") to bend back the inner cladding as some have had to do.

I would like to raise the front end by about 1"-2". I have read the threads on here about adjusting torsion, but it's not clear to me how much torsion adjustment I'll be able to get with stock parts. I read 8 turns is equivalent to about 1". Does anyone know what is the maximum adjustment possible?

EDIT: Also, this is kind of dumb question, but where are the torsion bolts exactly? This seems like some common tribal knowledge that I lack, since it was not conveyed in any of the "torsion" threads I searched.