Installing new Transmission Mode Switch.

The main stud that sit in the middle of the unit; where the linkage rotates broke off.

I soaked the bastard in PB cleaner for a good 20 minutes. Good news it sheared level with the mode switch orafice.

I'm pretty bummed though. No microfiche to secure new hardware, so I have to gamble if Merlin can pull it get me the right parts.

But before that I have to extra the broken one. Given there is 3-4 cm's exposed when I remove the unit I might be ok... I HOPE

Hopefully the stud is not a solid state build (I doubt it) and maybe is a two sided stud.

If anyone could chime in it would be very appreciated

df