Ok... well... I finally got that sumbeech installed.

When people say it's a tight fit, that's a load of crap. It's a f'in' impossible fit for someone of my size. Ugg... I think I might have permanantly damaged a nerve trying to get the interceptor installed.

Anyway...

My question is this; on the instructions, it says to install the red wire onto the main wiring harness... on the red wire with a silver stripe (as per Tones directions) -- but I don't have a red wire with silver stripe.

So I broke out the multi meter and measured line voltage on each pin. Well, in the process, I popped my check engine light. Anyway, while looking at it, I came across 5, 10 and 12 volt pins on the three pilons.

Which wire should I be hooking this to? Can someone give me a a pilon and pin number? Or a wire that actually exists by color code? Barring that, what sort of voltage does the interceptor require? 5, 10 or 12 volts?