Results 1 to 12 of 12

Thread: Swapping out TOD, installing Teras

  1. #1
    Member Since
    May 2003
    Location
    1990 Somewhat-Isuzu Amigo
    Posts
    27
    Thanked: 0

    Swapping out TOD, installing Teras

    I can't quite let this one go.... I know a few VXers received credits toward Tera gears in the Moab 'Zu Zoo VI raffle, and that they won't fit the TOD gearbox.

    I liked the TOD I drove in the ARB Project Compass Trooper, but I'd trade it in an instant ( heresey! ) for the Tera 3.07:1 gears. Not a huge change from the 2.48:1 setup, but one that you'd definitel feel!

    It would take some doing -- but I think it is possible. Swap out the TOD and swap in a salvage gear-driven case, with Teras.

    Just brainstorming, here, the primary issue is mounting the transmission to the transfer case... does anyone have pictures of the front of a TOD case? I have pix of the front of a non-TOD case!

    Secondary alterations would need made, possible ... changes to driveshaft length, floorboard alterations, and some minor electrical work. On the outside of the envelope, I could see crossmember and exhaust mods, but that seems unlikely.

    Anyone got the time, desire, and moolah to go exploring on this one? I'll help.... I think I can get the transfer case that mounts to the stock Isuzu auto tranny for under $250....

    Randii

  2. #2
    Member Since
    May 2003
    Location
    1990 Somewhat-Isuzu Amigo
    Posts
    27
    Thanked: 0
    BTW, if you wanted a manual transmission, this would be the time to slip one in... it wouldn't add all that much to the complexity (but would likely add loads to the cost!).

    Randii

  3. #3
    Member Since
    Jun 2002
    Location
    2000 Dragon Green VX 0485
    Posts
    379
    Thanked: 0
    Randii: I think the VXers that won the Terra gears should trade them for the 5.38s R&P for the front & rear axles If they would fit.

    1st gear ratio X Low Xfer ratio X gear ratio (R&P)= Crawl ratio

    Stock VX Crawl ratio is 29 (2.856:1 x2.480:1 X 4.10)
    With 5.38 R&P is 38
    With 3.07 Terras is 35.9

    http://www.4x4wire.com/ubb/ultimateb...;f=68;t=010931

    No way can I see trading a Manual for an Automatic.

    P.S Where are your Moab photos?
    Last edited by Green Dragon : 06/11/2003 at 08:13 PM
    Neither ordinary or extraordinary, just indefatigable.

    2000 VX Green Dragon- Chick Demagnitizer-Supercharger-Injen Intake- Cold air box-K&N- Power Vault SS Exhaust-265-75-16 BFG MT kms-On Board CO2- Custom Boulder Bars- Custom Skid plates- PIAA 520 Fog Lites-3inch lift with OME 912 Springs-LINE X Bedliner on Cladding & Hood Insert-ARB Front Lockers & Custom Bull Bar. Vintage Offenhauser Hood scoop Thule Rack. XM Radio-Custom Storage Box-First VX to surmount the RUBICON.Thanks Sierra Stompers

  4. #4
    Member Since
    Jun 2002
    Location
    00 00 00
    Posts
    1,627
    Thanked: 0

    Re: Terra gears?

    Originally posted by SPAZZ
    Tone, You tried to sell me some too, did you know these gears would not work for my VX? I may be Naive, but not stupid.
    Right, I'm sure Tone was trying to rip you off. Come on Tone, say it ain't so!!! NOOOOO!!! TONE!!!!!


  5. #5
    Member Since
    Jun 2002
    Location
    '99 Ebony Black VX, 0339
    Posts
    2,073
    Thanked: 0
    Gee thanks Spazz - I was under the impression they would work as they have been installed on Troopers with TOD - I’m offended you even dared mention that word.

    I didn’t find out until yesterday (6/11 - had not seen this post) when Tera got back with me - they are not even 100% sure - see mail below

    From: "Jim Walker - Tera Manufacturing Inc." <j.walker@teraflx.com>
    To: "Tone Monday" <tone@tonemonday.com>
    Subject: RE: Terra Low307 gear reduction for Isuzu VehiCROSS
    Date: Wed, 11 Jun 2003 10:32:23 -0600
    X-Priority: 3 (Normal)
    Importance: Normal
    Status:

    I would love to be able to sell it to you. But unless we actually install one I can't tell you if it will work or not. Isuzu's are difficult enough because they never use the same components in their drive trains. We had a hard time figuring out all the little quirks with there normal applications.__Being in a different vehicle you never know if something is different until you pull it apart. I wish I could help you out more.

  6. #6
    Member Since
    May 2003
    Location
    1990 Somewhat-Isuzu Amigo
    Posts
    27
    Thanked: 0
    Randii: I think the VXers that won the Terra gears should trade them for the 5.38s R&P for the front & rear axles If they would fit.
    The 5.38s should fit... and that's an interesting idea. The crawl numbers definitely work in favor of the R&Ps, but you'd have to be running at least 33" tires IMHO not to be revving too high during normal use, especially on the freeway.

    Worth following up on, for sure, but keep in mind that they don't HAVE to swap, and that their certificates were for specific projects, not general shop credit. Couldn't hurt to ask, tho!

    No way can I see trading a Manual for an Automatic.
    That's a personal preference. No way I could see driving a slushbox, either (but 210:1 gears will do that to a soul).

    Where are your Moab photos?
    Still in the camera. Running behind!

    Randii

  7. #7
    Member Since
    Jun 2002
    Location
    00 00 00
    Posts
    1,627
    Thanked: 0
    Emailing Tone directly to get in contact with him is usually easier than posting on the forum and waiting for him (or anyone for that matter) to sift through the messages, find the message, read it, and post an answer.

  8. #8
    Member Since
    Jun 2002
    Location
    '99 Ebony Black VX, 0339
    Posts
    2,073
    Thanked: 0
    I respond to emails that have legitimate questions in them that I actually RECEIVE (try sending again if I don’t answer you immediately) and can anwer.

    No one can delete but Scott.

    What urgent question can I answer for you now?

    No I don’t know what caused the exhaust to break.

    See the post above relating the TeraLow that I received at 10am AFTER I emailed you the nite before after finding a listing for the 307 for Isuzu’s with Automatics.

    I do not read all posts, nor reread posts after I post with few exceptions.

    Buh bye
    Last edited by Tone : 06/12/2003 at 08:15 PM

  9. #9
    Member Since
    May 2003
    Location
    1990 Somewhat-Isuzu Amigo
    Posts
    27
    Thanked: 0

    Re: Anyways......

    Terra Gears......... Will they or will they not fit VX.
    They will not -- that's why I started this thread in the first place.

    To get Tera transfer case gears into a VX would require swapping in a different (non-TOD) transfer case. Anyone wanna?

    Randii

  10. #10
    Member Since
    Jun 2002
    Location
    '99 Astral Silver #1321
    Posts
    182
    Thanked: 0
    This is a very tempting offer, especially with oversized tires and a blower that likes higher revs. I don't think I could give up my TOD - it's very effective for 90% of my driving, especially here in the Pacific North Wet where the roads are slick. Oh, but to have that lower gearing and a manual gearbox...

    Randii, you might try Allan (myabbaka@aol.com) who is a more hardcore off-roader.

    Thanks for the offer!

    Rick
    Rick "Baxman" LaMarche
    Supercharged, Dynamated. SCCA Oregon Region rallycross class winner

  11. #11
    Member Since
    Apr 2003
    Location
    1999 Astral Silver 1222
    Posts
    343
    Thanked: 0
    Ive never researched into it, but if I ever get a second VX, I was going to try the following- Most Troopers except old gen Troopers and the VX are very similar in the frame, engine, etc category. Possibly finding slightly used or refurbished parts except the engine (3.5 rocks for isuzus) from a pre TOD or a later model manual trooper. Plus the 3.5 SHOULD bolt to a 3.2's tranny (anyone?) This would be a complete change of 5 speed tranny, transfer case, driveshaft, and of course mounting. basically you would have a VX with the previous items completely replaced. Can you imagine how fast a 5 speed would be off the line as stock first gear runs up to 45 mph! Teralows are made for manual transfer case troopers, AND lower ring and pinnies AND some ARB's AND a Supercharger! Watch Out Moab. On a lighter note- at least Isuzu was kind enough to provide us with clutch holes in the firewall! LOL. I think stealing off Trooper parts is the key for any major mods we do Unless fully changing in another manufacturer. Mucho dineros though, and Isuzu has never let me down in 15 years so far.

  12. #12
    Member Since
    Apr 2003
    Location
    1999 Astral Silver 1222
    Posts
    343
    Thanked: 0
    Oh I forgot. Troopers come in S, LS, and Limited. The base models S were optional 5 speed with manual transfer case up until 2002 (Rare). Maybe someone could keep their eyes open for a wrecked one with low miles to boot.
    Last edited by MrCrowley : 06/15/2003 at 07:15 AM

Similar Threads

  1. Installing SBC Brackets
    By Buffy in forum VX Talk...
    Replies: 13
    Last Post: 01/09/2012, 01:40 PM
  2. Useful tip when installing new coil springs
    By jmayer40 in forum General Tips...
    Replies: 2
    Last Post: 05/08/2011, 11:31 AM
  3. Installing Super flexy IFS kit
    By Marlin in forum VX Modifications...
    Replies: 3
    Last Post: 11/01/2010, 04:37 PM
  4. Installing New Stereo
    By SomeBeach in forum General Tips...
    Replies: 14
    Last Post: 01/04/2010, 08:26 AM
  5. Swapping Air Systems
    By james1_10018 in forum VX Modifications...
    Replies: 1
    Last Post: 04/08/2003, 01:53 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails