skid plates

[don moore]

what do the skid plates look like ..I was at a junk yard and found some plates from diff. rigs ..what do the plates look like and were do they go ...I got one to cover the transfercase...it looks good..but i want better coverage

[etlsport]

just check inside the drivers side door jamb of each vehicle.. you are looking for a date of like nov 92 or later (93-00 i believe) on a trooper (not a trooper II) also could find an acura SLX.. the number of doors on the vehicle dont matter

[don moore]

thanks..... i found some loose plates but im not sure were they go..

[etlsport]

ah gotcha.. well ill snap some photos of mine when i get the vx in the air to install my lift

[don moore]

K thx

[VCrossfan]

Check this members link

http://http://www.vehicross.info/gallery/member.php?uid=289&protype=1

[rickshaw]

Everything you need to know about Trooper Skid Plates here.

http://www.vehicross.info/forums/sho...=&threadid=438

http://www.vehicross.info/forums/sho...&threadid=1704

http://www.vehicross.info/forums/showthread.php?t=4350



Photos from VX4EJR

Hope that helps.
_____________
rickshaw
Original Owner
2001 Dragon #0467

[don moore]

those are the ones I saw ..I have one so far $5
im going for the others .....soon
the one sure does hang down..but I guess it helps

[Ldub]

those are the ones I saw ..I have one so far $5
im going for the others .....soon
the one sure does hang down..but I guess it helps

IMO, the one nearest the right front tire doesn't offer much protection, in my experience, it offers only frustration.
My first Zoo, I managed to "make contact" with a rock on that one & it collapsed. Which caused it to "make contact" with the allen head bolts that connect the front output shaft from the transfer case.
The metallic snapping/grinding noise produced by said contact gets your attention real quick, and you soon find yourself in the red dirt turning wrenches.

[etlsport]

yea.. i hear you dub...



edit.. btw that jack stand is NOT holding anything up.. especially by the bolt

[Ldub]

Yep, that's it...and IIRC, I cut a good size chunk out of that area with the mini grinder to provide clearance, and that just allowed it to collapse further.
Anyone wants it, I'll bring it to Moab & it's yours for ten bucks.
BUT...you'll have to bend it back into shape until the mounting holes line up.

[Jolly Roger VX'er]

I'm not sure if I did the right thing or not, BUT, I had a local welder cut the lower hanging section off and weld in a plate up higher...net result...it now hangs no lower than the other plates/crossmember. He charged me $70. I'm still concerned with what you guys have experienced though.

[rowhard]

On the subject of skid plates and junk yards. Anyone remember what size bolts they are, or do you need to take your whole tool box with you?

[kodiak]

On the subject of skid plates and junk yards. Anyone remember what size bolts they are, or do you need to take your whole tool box with you?

Take your whole tool box with you! YOUR GOING TO MOAB!!!

Oops, maybe your not? I should read things a little closer before I post.

[etlsport]

theyre 14 mm.. i needed a long flathead screwdriver because one of the nuts inside the cross member had come loose and was just spinning, i had to wedge a screwdriver in there to get the bolt out