OBD II ScanGauge II Mirror Mount

[workmeistr]

Cool, Etlsport,
I do like it there. Since the ashtray should be accesible from any Rodeo (hopefully same front color?), I was thinking of lopping a section out of the ashtrap to recess the finished, normally-angled-front of the ashtray, so the ScanGauge would set flush straight up and down with the surrounding plastic, or even angled slightly up, then any visible gap(s) would show the finished front of the ashtray behind. Does any of that make sense?

I would not do it if I find out that VX ashtrays were a different colored front piece than any other Rodeo. I just bought a full Rodeo upper front dash surround off eBay, complete with all switches, to include R/Door Opener and fuzzy cubby switch panel replacement.

All need now is a lower CD-area dash section and I'll probably be off to my painter to have them painted Foxfire. Eventually door panels to match.

[workmeistr]

I got the ScanGauge II mirror-mounted.
BlendMount Mirror Mount:
http://cgi.ebay.com/ebaymotors/Facto...spagenameZWDVW

I got the Add-a-Gauge Model with an extra cable for use on the Saab.

I'll leave it there for the time being until another location calls out to me. It's nice to be able to angle it for optimal viewing. No real mounting and chord-routing issues, though the leading edge of my headliner almost seemed "glued" to the roof metal. I removed the pillar trim, sun visors, etc. to gently pull down the front of the headliner to route the ScanGauge cable through the existing mirror cable hole. I ran the gauge cable through the mirror's spiral cable.