Shortened a T20 torque screwdriver to reach the "hidden" 6th torque screw. It worked to loosen that near impossible to reach spot. All 6 screws are ready to be removed. However, still haven't managed to remove that electrical plug. I expect I'm going to be embarrassed when I eventually see how easy it should have been to unplug. The wire to the plug has no play so I cannot disconnect the module and access the plug even by loosening the brake lines.

Alltech said they could remove the module in less than 30 minutes, but they would not release my VX back to me until they installed the repaired module due to liability concerns. If I haven't figured out how to unplug that electrical plug by the end of tomorrow I will concede defeat, yet again, on another VX DIY project.