question and poll regarding abs module

[Mile High VX]

However, still haven't managed to remove that electrical plug.

On the right side of the plug you should see a T-handle. Pull that to the right, towards the engine, about 2". If it's stuck just wiggle it up and down (no comments from PK on this phrase is necessary...) while pulling to the right. Once it's all the way out the plug will pop out easily.

[Bill Brown]

On the right side of the plug you should see a T-handle. Pull that to the right, towards the engine, about 2".

That sounds like the harness connector, which was the easiest thing to disconnect. The small plug under the harness connection receptacle is the one that has me stumped. Pretty sure there is nothing 2" long associated with that small plug (circled in red).

Here's a side view from the engine of the small plug under the module:

Was going to see how difficult it would be to disconnect the wire bundle from the fender in order to get better access to the under side of the module and that pesky plug.

Thanks for your suggestions, Mile High VX.

[Mile High VX]

Mine had enough slack to move the unit up and then disconnect on the way out. Not enough to pull all the way out before disconnecting, but enough slack to move and disconnect.

[Bill Brown]

I was told to use a flat head screwdriver to depress a pin that would release the plug. Did you have to press a pin? Please describe where that pin is located. Was it near the top of the plug? Did you need a screwdriver and did you hold the screwdriver blade horizontally?

I seem so close to resolving this issue without resorting to the sledgehammer nuclear option.

[Mile High VX]

Not sure exactly...just don't remember it being that hard.

Shop manual doesn't even mention that connection.

[Bill Brown]

Well, I may just have to actually resort to Alltech to handle an easy fix that was too much for me, yet again. Good to know I'll be helping a tech's kids enjoy a bit merrier Christmas.

I do okay when components are readily visible, but DIY projects requiring me to feel my way around are costly: minor scrapes, cuts, back strain, etc., plus lots and lots of wasted time. Really aggravating to be so close, but to get stumped by a simple plug. Had a similar experience replacing my stock flasher with a LED compatible one. Wasted lots of time, strained my back, etc., then ended up taking the VX to Alltech.

Update: Sunday, 16 Nov 2014

2:30 p.m. - Removed the small plug, undamaged, and removed 4 of the 6 screws. The lower left 2 are proving to be more challenging than anticipated. I can see where having the right tools would have made this task a breeze, such as appropriate length T20 screwdrivers/bits with a small ratchet wrench.

[soggybottomboyz]

How did you get the plug out?