Brake Clunk

[SilverBullet75]

Oh... the reason why (theory) this fixed the clunk...

The pre-load is eliminated by mounting the exhaust, which acts like a lever.

[SilverBullet75]

Ok, same issue resurfaced again. "Brake" clunk when releasing brakes after a stop. I went under today and pushed on the exhaust near the hangers. I noticed that when I pushed hard/agressively enough, the exhaust on the TOD side hit the cross member. So, I took a heavy-duty hose clamp and clamped the rubber mount for the exhaust at both mount sites. Wah LAH! No more banging.. again. (The original remedy (2 posts up) did fix it... it's just that the rubber stretched a bit over 6 months. The clamp just rejuvinated the fix )
I also lubed the rear propeller-shaft zyrks.
Again.. a happy VX.
I'll have to keep an eye on this every few months...
Next, to replace all fluids.

[IndianaVX]

i have a post where this is discussed, because i did, and still do occasionally have that clunk, and i have a theory that i havent been able to look into yet.
when i did my front brakes, as i put things back together, i noticed some markings on the caliper bolts, and when i looked it up in the manual, of course, i had them in the wrong places. it seemed to me that there was a diameter, or some flat spots....there was something different about the two bolts, even though they fit and tightened down ok.
SO, my theory is this....that at some point, maybe the rear brakes (where i hear my clunk) were worked on, and the bolts were put in the wrong place.
this may be causing just enough friction on the wrongly placed bolts to not let the caliper release until the wheel starts to roll again.
in my thread, it was described perfectly as "unsprung energy"
just a thought, and just another thing i want to tear into to try and figure out my clunk. its been probably 2 years, but i will get around to it......

http://vehicross.info/forums/showthr...nsprung+energy

or type in the search "sticking brakes" in case i didnt do the link above correctly
the same discussion of drivetrane lubrication came into play on that thread too.

[Chopper]

I've always had one rear (pass side) that thunks on release. Like it's just a bit slow. It never affected anything, so I've never screwed with it