best $3.22 spent on the vx

[etlsport]

sweet yep thats the one.. how was the install?, i have a 1" round one back there now that went kaput on me within like 2 months

looks like you cut the filler panel in half? did you end up gluing it in place after that? where did you mount the bracket? I was thinking about making a metal plate to go top to bottom in the recess and then bolting the camera itself to that plate, instead of using that bracket

[kodiak]

I used a lot of gray RTV. It’s strong and watertight. The bracket fits perfectly over the camera. I used Gray RTV on it as well.

P.S. Don’t use Clear RTV it’s not as strong.

sweet yep thats the one.. how was the install?, i have a 1" round one back there now that went kaput on me within like 2 months

looks like you cut the filler panel in half? did you end up gluing it in place after that? where did you mount the bracket? I was thinking about making a metal plate to go top to bottom in the recess and then bolting the camera itself to that plate, instead of using that bracket

[etlsport]

got mine installed.. not quite as nice looking as yours is kodiak, mine is set in a little farther, i wanted to get as close to the vx bumper as possible.. the end result is that in these photos, i can see about half of the spare tire, the red funnel and all of the spare tire carrier on the ground in these photos

[pbkid]

looks to me like you got it at a perfect angle...you should be able to see ANYTHING behind your VX

[JoFotoz]

$24 ...RV rear view plastic lens .

Cut..fit......SEE ALL!...park within 4 inches...no worries.

Thats my take...


jo

[circmand]

at Pep Boys for $99 and had a local stereo installer put it at the top of the license plate for another $60 (Pep boys wanted like $300) Works very good. The only problem is the glue holding the stand gets loose in the heat.