ok, so i ordered a bunch of stuff for my VX when i got my tax return...however, a lot of it required me to run wiring, so i decided i would take my interior apart and do it right....

please forgive the poor quality pics, taken with 2mp camera phone

so i did a quick write up for everyone-
use a pick tool to pull the ends of the caps that go over the grab handles...


so, this is what it will look like after you pull the caps off


next pull all the 'christmas tree's' off...


next you need to remove the seat belts...i did the rear first...


i used the hook pick tool to pop the covers off the front seat belts


next you will need a T50 Torx bit to remove the top of the seat belts



remove the bottom of the front seat belts


there are about 15 pressure clips that hold the rear part of the panel on... i started by pulling on the area near the rear at the top...


the bottom is pressure clipped and velcro'ed


next i pulled the panel to pop the strange clip near the doors...


then push the whole panel towards the 'front' of the vehicle to get it to let go of the edge of the door


then, if you look behind the panel, the piece around the seat belt unclips.


this leaves you with only the rear part...


screw here...


screw here...


unscrew this with your hand


take these two screws out


unclip this cover over the top of the seat belt


then same as the front, look behind and unclip the cover around the seat belt

keywords- interior, removal, rear speakers, grab handles