Power Door Locks Not Working

[Trap11]

I found the problem!!! From another thread years ago!! Thanks.

Hotsauce09/29/2003, 04:04 PM
This happens when the connector to either door switch gets loose.

Grab the front edge of the panel holding the window switches, and swing it up. Unplug the connector to the switch, and reconnect it, this should solve this.

John C.

[kirk hilton]

This also happened to me but it was the standard 5 pin relay that puts 24v to the motors from the ignition switch that was faulty (cost me 3 quid replace). The relay is located behind a plastic panel in the driver's foot well (JDM right hand drive)

[a745035]

I found the problem!!! From another thread years ago!! Thanks.

Hotsauce09/29/2003, 04:04 PM
This happens when the connector to either door switch gets loose.

Grab the front edge of the panel holding the window switches, and swing it up. Unplug the connector to the switch, and reconnect it, this should solve this.

John C.

Trapp, your old post of Hotsauce's old post is still helping folks out. My '01 Foxfire's power door locks haven't worked for 3+ years... now they do! Thanks a bunch. - Brian