will these rims work/bore size

[djvx]

I'm looking at a 2nd set of wheels for non winter use. Will xd rockstar 18x9 with 0 offset and a 106mm bore hole and 6x1.39.7 bolt pattern work on my lifted vx-assuming I install terra grapplers @ 285/60/18. Mainly I am concerned about bore sizing.The mfg will no longer offer a 100mm bore so is there a spacer / ring for the slightly larger bore?

[tom4bren]

You shouldn't need a spacer, we are lug centric. The only problem will be during mounting & aligning the studs to the holes since the hub won't be helping you. Really not a big deal. LittleBeast mentioned it in one of his threads.

As far as the offset, you'll have to read through the thread on that but IIRC it sounds right.

[djvx]

thanks tom i'll search that.

[tom4bren]

Here's where ya wanna read up on offset:

http://www.vehicross.info/forums/sho...ht=LittleBeast

I'm still lookin for the LittleBeast thread on his centerbore.

EDIT:

Can't find the thread I'm thinking of but I did find this old one that may give you some of the info you're looking for:

http://www.vehicross.info/forums/sho...ght=centerbore

[djvx]

tom- that second link isn't a thread....it's a horror story! so is our hub bore 100,or 110mm

[WormGod]

You should be concerned about trimming too. "0" offset will have you trimming front and rear of the front wells. I have 18x8.5 (0 et) and considerable trimming was done to make room for 285/60s.

[ZEUS]

tom- that second link isn't a thread....it's a horror story! so is our hub bore 100,or 110mm

108mm - H3, Canyon, Colorado, I-350... all share a 110mm bore so wheels made for them should also work for a VX.

[djvx]

Thanks---and if anyone else has advice I'll take it. WormGod I'm going to find your gallery and see what that looks like. Thanks Zeus also