Abs tone ring

[VX crazy]

could someone post a picture of what this looks like......

[Ldub]

could someone post a picture of what this looks like......

You'll see it at about pic 9 - 10 down from the top here...

http://www.vehicross.info/forums/showthread.php?t=11324

[erland]

ok I have the new tone ring installed seemed to not fit properly, made a little noise when first starting to go but quits when gets up to speed. How can I get the abs light to go off?

[Ldub]

ok I have the new tone ring installed seemed to not fit properly, made a little noise when first starting to go but quits when gets up to speed. How can I get the abs light to go off?

IMO, it shouldn't be making any noise at all, there is most likely a fitment issue. (sounds like wrong part from your description)

I just installed my old tone rings on new rotors, there is no noise at any speed.

[erland]

Called R1 concepts, they are sending me a new rotor, the bolt holes are misaligned.

[Ldub]

Called R1 concepts, they are sending me a new rotor, the bolt holes are misaligned.

I'd be interested to know what was making contact to cause the noise, I hope it wasn't the $peed $en$or...

[TechnoPope]

I just did the same upgrades and had to replace one of the abs rings. The job is done and the brakes work fine, but the ABS light is staying on and the ABS pulse is not evident. No codes are detected and attempting to clear the codes does not reset the light. All of the sensors at the wheels are sending signals. Fuses are back in place and functional. I left the VX with the mechanic to fiddle with, but he is short of ideas that won't get into a lot more money. Could the ABS module be bad? Any ideas? Thanks.

[erland]

I'd be interested to know what was making contact to cause the noise, I hope it wasn't the $peed $en$or...

I believe the new rotor holes were misaligned causing reing to not sit flush causing a slight bow so teeth do not line up with sensor properly.