What is this metal Rod behind cd changer?

[Mrmonk7663]

Hey guys. Need help identifying something. I have no CD changer, it has been removed. Inside the hole I was looking around and i found a metal rod towards the rear right hand side. It has a small L shape on one end and appears to be some kind of threaded end on other. I also see a white plastic arm. To me it appears this rod attaches to the white arm with the L end....but I have no clue where the "threaded end" goes. Also, I have no clue what this part is or what it is for? I assumed for HVAC but my heater works my AC works my defroster works....and this metal rod is not attached so I don't know.

Thanks,
Michael

[etlsport]

i know what you are talking about, not sure what it does exactly, my best guess is that it opens and closes dampers to re-direct the air from defrosters to vents to floorboards

at first i thought it might be for the shift lock release but i dont think thats it either

[Mrmonk7663]

I don't know. Everything works fine. Do u know how to hook it back up?

[Gussie2000]

Hey guys. Need help identifying something. I have no CD changer, it has been removed. Inside the hole I was looking around and i found a metal rod towards the rear right hand side. It has a small L shape on one end and appears to be some kind of threaded end on other. I also see a white plastic arm. To me it appears this rod attaches to the white arm with the L end....but I have no clue where the "threaded end" goes. Also, I have no clue what this part is or what it is for? I assumed for HVAC but my heater works my AC works my defroster works....and this metal rod is not attached so I don't know.

Thanks,
Michael

hi michael !

some pics can be helpfull.

[deermagnet]

On my '99 there's a threaded end and white plastic part right above the gas pedal. That controls the flap that shuts off air flow to the floor when you select defrost only. It might be different on a '00-'01.

I've had to adjust it twice so far 'cuz I was getting too much air on the floor when I wanted it all up top. I separate the two parts and select defrost only, then move the flap arm to close it tight, then snap the threaded metal part into the groove in the white plastic part. The threads are there to keep it from sliding out of position. Then it closes tight when I select defrost.

I hope that's what you're talking about.

Mark

[Mrmonk7663]

Well I'm not talking about by the gas pedal but it sounds like same type of part. I'll see if I can figure out where the threaded end goes when I get off work. Thanks for the help yall.

Michael

[deermagnet]

Yeah, a '99 has different air controls, so yours might be on the other side. It sure sounds like the same gizmo as mine. Let me see if I can get a photo.

Mark

[deermagnet]

Okay, I got the photo from my '99 on the driver's side.



Mark