Brakes/Rear Door Panel.

[O Hell No O]

So I installed the VX Retail CD, and it doesn't respond O.o, I downloaded the 100mb+ file and used MagicISO.

I guess it doesn't work in Windows Vista?

[Triathlete]

Try putting it on a CD. If I remember right...its been a long time...that should work.

[MSHardeman]

deermagnet did a great write-up on how to replace the rusted out license plate bracket: http://www.vehicross.info/forums/sho...+plate+bracket

As for the brakes; I'm not too sure about the squeeling, but you do need to have the engine running to bleed the brakes properly on a VX. I had Merlin at St. Charles Isuzu send over some instructions, and it did say to have the engine running. I can send you the pdf if you would like because I can't figure out how to post it up here.

[O Hell No O]

Allrighty, thanks for that walk through. Also I still can't get that CD to work. Not sure what i'm doing wrong. I've put only the ISO file onto CD, didn't work. I've extracted the ISO and put all the extracted files onto the CD and still doesn't work. Any ideas?

[O Hell No O]

Hardeman, you can send that PDF file to Battlefield2142.Pilot@gmail.com

Thanks!

[deermagnet]

This is our bleeding procedure I posted here before. You have to remove the ABS fuse, and yes, the engine MUST BE RUNNING!







Mark

[MSHardeman]

Mark must have posted the bleeding instructions just as I was hitting send on an email to you. The instructions that Mark posted are the same ones that I got from Merlin.

Thanks Mark, because now everyone can see them.

[rowhard]

So I installed the VX Retail CD, and it doesn't respond O.o, I downloaded the 100mb+ file and used MagicISO.

I guess it doesn't work in Windows Vista?

It's downloadable here under downloads and only needs a adobe reader which is a free download if you don't have it. Also the Electrical manual is there