These are to use on our rear springs right? Would it be too much to add to a set of 912's? Would that make too much lift if I tried to raise the front to match? Would it cause undue wear with the front u-joints?
These are to use on our rear springs right? Would it be too much to add to a set of 912's? Would that make too much lift if I tried to raise the front to match? Would it cause undue wear with the front u-joints?
Bob,
It's not the U-Joints that are the problem, it's the CV joints. The good news is that a 2 inch lift SHOULDN'T hurt either one.
I stress "shouldn't" because a lot depends on the condition of the CV Joints before the lift. Many members have done a 3 inch lift without hurting their CV Joints so I'm guessing you'll be fine.
Tom
[SIGPIC][/SIGPIC]
Put a smiley after you say that Bub.