good luck with the install! A couple of tips..

the intake tube comes very very close to the radiator fan. I had to shave about 1/8 inch off the front of the intake to make it fit. also modified the bracket that holds the filter up to push the intake tube a little further from the fan. works like a charm. If you can find a new IAT sensor grommet, I would try to get one before installing. During my install, my grommet got pretty badly beat up.

I was actually on a grand prix forum and found this extension that should work on our IAT sensor so you could move the sensor closer to the air fliter for better performance and so you don't have to stretch the wiring to fit into the morgan tec intake (i had to pull my wiring an inch or so to get it to reach the spot on the new intake)
http://www.zzperformance.com/grand_p...=184&catid=108

any problems/questions feel free to ask, i installed mine within the last 6 months