Quote Originally Posted by Grif View Post
Ok, got my two bottles of "Showroom New" black, and even a spare bottle of 3M (bondo) "Restore Black" dye as a backup, plus at least one or two applications of R/R left in my big tub of R/R.

BTW: reviews of the "Restore Black" 3M product on this site indicate much the same results as the other dye products. I frankly am thinking all dye products are essentially the same, and require multiple coats and patience to set in and careful application.

So Kat... before I proceed. Final thoughts on applying "Showroom New"? Applicators, technique , prep beforehand? My cladding is in generally good shape, not too faded, but some nasty trail rash. Want to get black, not shiny, just mask the rash get an even color and remove some moderate fading.

The plan so far is wash traditionally, prep with denatured alchohol (which I find is a great cladding cleaner) and apply the dye(s) lightly in three or four coats, 8 hours time to set tween coats, using a terry coated foam pad.

Got a prob with that? hehe
Sounds perfect. I did notice the prep instructions said to wash plastic with soap....was surprised it wasn't more involved. But I'd do what you outlined with the denatured alcohol.

~Plan on only doing no more than 2 ft at a time.

~I just dipped the CORNER of the square sponge pad with terry cloth, got about 1/2" - 3/4" of dye on that corner.

~Splotched/dabbed it on a few places of my intended work area, than started doing the wiping with the pad.

~As the sponge absorbs more and more dye, you can press/squeeze on it harder with your fingers to discharge more dye while you are applying it.

~After you get the wettest part applied, (after just a few strokes) then use progressively lighter pressure to kind of smooth the product.

~when it's wet, it can look very streaky.....wait it out until it's dry for a day or so.

~it definitely surface dries faster in warmer weather.

~A big mistake I made was to keep wiping and wiping trying to get it perfect....the product ends up drying out by doing that and then you can't get it smoothed out. That's what went wrong on my front driver's corner.

~Plan your stroke pattern ahead of time on the front corners.

~Don't try to stretch the product- HUGE MISTAKE, makes it dry even faster.

~It comes off the paint really pretty easy, so don't freak if you get some on. I used a vinyl eraser for some spots that were a little tougher and didn't "scratch off" with my nail.

~I have 4 coats on, 3 was actually better...aim for 3.

~With that in mind, if you see an area drying too much and you still want to smooth it out, dip the sponge again, add more dye and try it again.

~Yes, you can add fresh dye onto wet area you just did. It's like a 2nd coat.
May want to go a little heavy with it over the trail rash areas.

~I did it sitting on a rolling stool, was perfect level and allowed me to do wide swipes on the door panels particularly, so I swiped from front door edge to rear door edge, as straight across as I could.

If you find the sponge terry cloth thing isn't putting enough product on, maybe try a foam brush for coat 1 or 2, it will put more product on than the terry sponge.

It is definitely not a shiny product AT ALL, it's has a little bit of sheen in sun, but not much.

Take pics!

Wish Atilla would post some pics or give some more input.

Good luck!