P.S. If it's a big headache I can just drill the second hole after I buy it. I guess the important thing is to make sure the first hole is placed as to leave enough room for the second hole to be drilled.
P.S. If it's a big headache I can just drill the second hole after I buy it. I guess the important thing is to make sure the first hole is placed as to leave enough room for the second hole to be drilled.
mine had 28mm from the back of the hole to the collar....so if WelderGuy moved it more aft 1/2" for use goofballs....that probably means it would be really really tight to get another hole and still have some metal integrity....???
It's more of an issue with the second hole being in line with the primary (pin) hole in the direction of the most significant force (draw weight). As long as there is at least 2x the wall thickness of the tube between the two holes, it should be fine.
You're taking me entirely too seriously ... but what's next, duzzit hafta be powder coated an exact match to foxfire???
I have no response to that.
[SIGPIC][/SIGPIC]
Put a smiley after you say that Bub.
WooHoo!!!
Cladding now fits over the hitch. Need to drop it off to Welder Guy this week to finish her up (full welds, clean up, & paint).
Will keep you posted & add some pix next week (middle of week - gotsa run to Vermont on Monday for work).
No J pin hole yet, but we'll add that.
Prolly gonna mount the safety chain loops tucked under - harder to get to but cleaner look ... hope that's OK with everyone.
I'll try to get him to extend the mounting brackets down so that you can add a shakle on both sides if you wish. Feedback on hole for shakle???
Woohoo! Can't wait. If you're talking about a shackle (like d-link?) on each extreme end of the bracket for recovery, I personally think it's a GREAT idea... adds versatility, and you could always remove the shackle/link if you want. Thanks for the update Tom!
Tom, are you talking about adding clevis shackle mounts like the ones pictured below?
![]()
Yah, dat's what I'm talkin 'bout.
http://www.vehicross.info/gallery/sh...user/3558/sl/v
The mount for the clevis shackle is actually part of the bracket for the rear bumper under the cladding. 80% of that bumper is going away (including that mount). I'm not sure if there is any benefit on adding it to the drivers side since the tail pipe will be in the way for using it but I'm sure some would like the one on the passenger side.
As promised, here are a few pix of the hitch before it goes back to Welder Guy tomorrow.
When you see welder guy tomorrow, can you please get a final price? I think i read $250 somewhere but wasn't sure if that still stands.
Also, not sure if he's ready for orders but you can let him know Jon in CO thinks his design looks REAL good.![]()
So whats going on with this build? Ill definatly be getting one of these when its complete
Got a call from Welder Guy last night. He has 2 hitches tack welded together for me to fit check before he does full weld/finish/paint. Hope to pick them up tomorrow. If they both work out, he'll be able to put together a jig to start cranking them out. Will keep you posted.
Tom
Silly question, what is going the pull weight on it? what size is the square tubing 1/8 or 1/4?