Page 2 of 7 FirstFirst 1 2 3 4 5 6 ... LastLast
Results 16 to 30 of 97

Thread: overheating is back

  1. #16
    Member Since
    Jun 2002
    Location
    1999 silver 1346
    Posts
    505
    Thanked: 0
    just one more question, i took off the radiator cap and let the car run for about 10 minutes and noticed that the antifreeze never went down just rose to the rim and slowly spilt out (little bit) shouldnt the level have went down if the thermostat opened?

  2. #17
    Member Since
    Mar 2006
    Location
    2001 FOXFIRE 0579
    Posts
    887
    Thanked: 0
    Quote Originally Posted by zadam123 View Post
    just one more question, i took off the radiator cap and let the car run for about 10 minutes and noticed that the antifreeze never went down just rose to the rim and slowly spilt out (little bit) shouldnt the level have went down if the thermostat opened?


    It should, if the thermostat is working as IT should..... And I would think this bolt repair..... There's alot of stuff that's gotta come off to get to it, price will be accordingly. Sorry this happened, good luck!

  3. #18
    Member Since
    Jun 2002
    Location
    1999 Astral Silver VehiCROSS #1214
    Posts
    242
    Thanked: 1
    The way the technician explained the problem to me was exhaust from the combustion chamber was making its way into the radiator fluid (we could clearly see the path across the head gasket too) and this was over-pressurizing the coolant system causing the flow to be much slower or completely stopped (almost like having two pumps pumping in opposite directions).

    I never tried running the VX with the radiator cap off so I don't know what to tell you there.

    A decent garage should be able to determine if the head bolt is broken off in an hour or two, so check their hourly rates. Tell them not to loosen any of the head bolts, just look for a broken one. Once loosened, you have to replace them with new bolts. You might be able to get away with just replacing the one bolt, assuming they can get the broken piece out.
    -Paul

  4. #19
    Member Since
    Jun 2002
    Location
    1999 Astral Silver VehiCROSS #1214
    Posts
    242
    Thanked: 1
    The thermostat is way simpler/cheaper to replace so do that first if you haven't already. But I'm guessing the bolt problem would cause the same slow overflow you saw with the radiator cap off.

  5. #20
    Member Since
    May 2010
    Location
    1999 Ebony 1716
    Posts
    1,196
    Thanked: 0
    Again, don't forget you can burp the system to get an air pocket out. IF there is air in it, the thermostat will still open, but it won't circulate because the water pump blades are essentially spinning in an air pocket. Find some ramps, or some tall jacks, get the front all the way up as high and safe as you can and find the high spot in the system. Run the car until it's warm and you are sure the t-stat should be opening and open up the high spot, it may be the cap since it's in the middle of the radiator unlike a lot of other cars. It may be a bolt I can't find. But it's free and worth a shot. If you see a lot of bubbles coming up when you open the cap and the truck heats up then make sure you have some extra fluids on hand to put back in there so another air bubble doesn't get in.

    Worth a freebee shot.

  6. #21
    Member Since
    Jul 2003
    Location
    '01 Ebony #0939
    Posts
    2,142
    Thanked: 5
    Quote Originally Posted by Bob Barker View Post
    ...Run the car until it's warm and you are sure the t-stat should be opening and open up the high spot, it may be the cap since it's in the middle of the radiator unlike a lot of other cars. It may be a bolt I can't find. But it's free and worth a shot. If you see a lot of bubbles coming up when you open the cap and the truck heats up then make sure you have some extra fluids on hand to put back in there so another air bubble doesn't get in.

    Worth a freebee shot.
    My car actually has a second radiator type cap incorporated into the intake casting at the designated high-spot that makes burping the system very easy. I looked in our manual and didn't see anything specified as far as any designated "high spots" in our cooling system though.

    All the manual really says for our systems is that re-filling the system at a slow rate once any work is completed is the best way to prevent air pockets from forming.

  7. #22
    Member Since
    May 2010
    Location
    1999 Ebony 1716
    Posts
    1,196
    Thanked: 0
    The Mach 1 I sold had a cross over pipe between the heads that had a really hard to remove bolt. May be something like that with our trucks.

  8. #23
    Member Since
    Apr 2011
    Location
    1999 Astral 0074, 2001 Proton, 1999 Ebony, 1999 Astral 0163
    Posts
    367
    Thanked: 0
    Sounds to me like your head gasket. Last year before I bought my VX, the previous owner spent almost $3,000 getting the heads fixed. The mechanic that worked on it apparently didn't machine the heads down properly nor did he tighten the bolts as much as he should've.....my baby has just now gotten out of the shop getting the heads fixed again. Luckily, I paid for parts and that's it. My mechanic is one of my best friends. I didn't know my head gasket was blown, there were no symptoms, except for a little overheating, under the same conditions you've experienced. There is something called a "block tester"...costs about $45 from NAPA. Follow the instructions and you can find out if there is combustion leaking into your antifreeze. THAT will happen before antifreeze leaks into your oil. Once antifreeze leaks into your oil, your on your way to bigger and more expensive repairs. So catch it early! You can buy this block tester and check it yourself or let a mechanic charge you $300 to do the same thing. At least if you do it yourself, you'll know what your mechanic needs to fix instead of them charging you to look at it, test it, tell you what's wrong, and then finally charge you for working on it. They might "find" a lot wrong with it, charge you for it, and you'll still have the same problems because they didn't fix the correct thing in the first place.

  9. #24
    Member Since
    Jun 2002
    Location
    1999 silver 1346
    Posts
    505
    Thanked: 0
    ok he told me he did a compression test and it was good, he said that my thermostat was a aftermarket one and was the wrong temp (i think he said it was a 170) he said i need the 190 OEM one and is in the prosess of changing it , I told him it would seem that the 170 should make run cooler but he said aftermarket ones are no good and may not open all the way.well see tommorrow

    as far as the block tester is that like a compression test?

  10. #25
    Member Since
    Feb 2007
    Location
    2000 Proton VX - 0776
    Posts
    9,258
    Thanked: 0
    I've been fighting a similar battle with my 03 Eclipse for 2 years now. I've finally gotten it to where although it runs hot in stop-n-go traffic, it doesn't overheat.

    What I've done so far:

    1. Shop replaced temp sensor. They replaced the wrong one though. They replaced the one for the temp guage instead of the one that turns the fan on/off.

    2. I replaced the correct temp sensor but it didn't help.

    3. I replaced the water pump (was told that it could be that the vanes on the water pump were eroded to the point that it wasn't moving enough coolant). That didn't fix the problem either & the old pump looked fine. BTW, I replaced the timing belt while I was in there.

    4. I replaced the thermostat twice (once with aftermarket & once with OEM). That didn't fix the problem either. I'm running without a thermostat right now.

    5. I tried repeatedly to burp the system with no success. I was told that the system could get a bubble behind the thermostat which would cause it to not open. I even drilled a hole through one of the thermostats to allow any bubbles to seap through.

    6. Replaced the relay that turns the fan on/off. It was dead & now I can drive it without the fear of overheating (even though it still runs hot according to the temp guage).

    Eventually I'll put the thermostat back in & probably replace both temp sensors again but there's no rush. The only problem I have running it without the thermostat is that I get a CEL about once a week during the winter indicating that the engine is running too cool.

    I know the vehicles are very different but maybe you can glean something from my trials.
    [SIGPIC][/SIGPIC]

    Put a smiley after you say that Bub.

  11. #26
    Reading the last post something occurred to me. Have you checked to see if it actually running hot? Is it simply a gauge error?

    Different situation but I once had an English car when for some unexplained reason once the car warmed up the temp gauge went to the peg, if the headlights were on. If you turned the dash lights down the gauge went down as well. The engine was not running hot.

  12. #27
    Member Since
    Feb 2007
    Location
    2000 Proton VX - 0776
    Posts
    9,258
    Thanked: 0
    Quote Originally Posted by rsteinmetz70112 View Post
    Reading the last post something occurred to me. Have you checked to see if it actually running hot? Is it simply a gauge error?
    Yah, I thought of that too. That's why I plan on replacing the sensors again eventually. Too many other pots on the fire to worry about it right now though.

  13. #28
    Member Since
    Apr 2004
    Location
    2000, Ebony, VX, 0370
    Posts
    2,503
    Thanked: 12
    Do you have a ScanGauge, or some other OBDII reader that you can hook up to the car (either of you)? That way you could get a temp reading off the ScanGauge and bypass the dash gauge to see if it is reading correctly or not.
    "The major difference between a thing that might go wrong and a thing that cannot possibly go wrong is that when a thing that cannot possibly go wrong goes wrong, it usually turns out to be impossible to get at or repair."
    -Douglas Adams, Mostly Harmless

  14. #29
    Member Since
    Feb 2007
    Location
    2000 Proton VX - 0776
    Posts
    9,258
    Thanked: 0
    I do have a scan guage ... but it's in the RV. Last time I hooked it up in the 'Clips, it turned off my speedo. Wierdest thing I ever saw. I'll give it a shot though, now that the hot weather is here, it may give some interesting results.

  15. #30
    Member Since
    Jun 2002
    Location
    1999 silver 1346
    Posts
    505
    Thanked: 0
    also as far as the block tester I did have a mechanic stick in old emissions tester ( the 1 used for your tail pipe) into the radiator reservoir tank and it did show a little co2 there. but no other mechanic has ever heard of this test. it seems like the same idea it is just that every mechanic is telling me it is not a head gasket. it is so hard to find a good mechanic

Similar Threads

  1. VX overheating...what haven't we done?!
    By KristyRemo in forum VX Troubleshooting...
    Replies: 3
    Last Post: 08/12/2016, 05:28 AM
  2. overheating already
    By angeno in forum VX Talk...
    Replies: 16
    Last Post: 05/15/2014, 08:42 AM
  3. help overheating
    By zadam123 in forum VX Troubleshooting...
    Replies: 40
    Last Post: 09/03/2010, 10:32 AM
  4. supercharger overheating
    By spitfire5454 in forum VX Troubleshooting...
    Replies: 17
    Last Post: 09/02/2008, 10:43 AM
  5. Overheating
    By bobmumgaard in forum VX Troubleshooting...
    Replies: 2
    Last Post: 06/27/2007, 12:51 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails