Results 1 to 2 of 2

Thread: transfer case removal... not working for me...

  1. #1
    Member Since
    Nov 2008
    Location
    2001 VehiCROSS PROTON JAVCN77X8Y7D00713
    Posts
    29
    Thanked: 0

    Wrench transfer case removal... not working for me...

    Ok, I have got all 6 bolts off the transfer case and trying to separate the transfer and the transmission. i have front and rear drive shafts off and exhaust off, no separation it is like it is glued but i do not want to break one or the other....

  2. #2
    Member Since
    Apr 2004
    Location
    2000, Ebony, VX, 0370
    Posts
    2,503
    Thanked: 12
    I'm no expert on this (AT ALL), but I'm sure that the transmission and transfer case have "fused" themselves together over the past ten or eleven years. I would think a couple of whacks with a rubber mallet, or dead blow hammer, would persuade them to separate.
    "The major difference between a thing that might go wrong and a thing that cannot possibly go wrong is that when a thing that cannot possibly go wrong goes wrong, it usually turns out to be impossible to get at or repair."
    -Douglas Adams, Mostly Harmless

Similar Threads

  1. Transfer case #'s
    By simonsayz1 in forum VX Talk...
    Replies: 4
    Last Post: 01/29/2015, 01:01 PM
  2. Transfer Case plug removal
    By ariastwin in forum VX Troubleshooting...
    Replies: 5
    Last Post: 11/10/2012, 12:08 PM
  3. Removal of Front Propeller Shaft and Transfer Case?
    By sleveritt in forum General Tips...
    Replies: 27
    Last Post: 06/02/2011, 04:34 PM
  4. 2WD transfer case?
    By So-CalVX in forum VX Talk...
    Replies: 1
    Last Post: 03/03/2008, 09:40 PM
  5. Transfer Case
    By yal^ in forum VX Troubleshooting...
    Replies: 14
    Last Post: 04/16/2005, 10:12 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails