Solutions to Window & Cup Holder

[Bulldoggie]

I recall there was one owner (Bulldoggie, and then tysamigo) that neither of the above helped. He tried putting some metal washers in a stack, maybe 1/2" or so, to act as spacers and push the bottom of the glass outward, and of course that made the upper part of the glass tilt inward more. I believe that solved the tilting and jumping the track issue. I recall he just kept adding washers (thickness) until the angle was optimized.
http://www.vehicross.info/forums/sho...8&postcount=38

I used the washers to keep the horizontal window guide arm from separating from the guide track. like your picture shows. Since the amount of separation is different for all, the amount of washers varies.
there are pictures in my gallery showing this detail.
I test the alignment by checking how the glass rests on the mount while it is unbolted in various up/down positions.
the glass should rest on the center of the top of the mount while the mount is snug to the track.

In other words; the glass runs in fixed guides front and rear.
When the mount separates like yours, the track is not aligned, so the glass pulls the mount away from the track.
It is not a problem with the track guides!

[Bulldoggie]

and yes! this alignment of the track fixes the window from pushing outward of the weatherstripping, while going up.
When the mount is pulling away from the track, it is also pulling the bottom of the glass inward, forcing the top of the glass to tilt outward.

the other fixes are for the window binding/tilting at the front by the mirror.