Results 1 to 8 of 8

Thread: TOD Flashing Light

  1. #1
    Member Since
    Oct 2010
    Location
    '01, Foxfire Red, 0260
    Posts
    3
    Thanked: 0

    TOD Flashing Light

    Yesterday, the warning light beneatn the TOPD indicator began flahsing. I took it to a trusted mechanic, who diagnosed (or attempted to) but nedds additional time. It seems all wheel sensors are working fine, but there's a suspicion of a "short to ground." They will need to remove the passenger seat to access the control module and any associated wire harnesses.
    I have an appointment with the dealer, but I'm uneasy: no bad experiences; just prefer not to pay the higher labor rates, plus the cost of a new contol module. The car has 111K miles on it. 2001

    Any thoughts or similar experiences?

    Thaks,
    Chris.

  2. #2
    Member Since
    Jan 2008
    Location
    1999 Astral Silver 0481
    Posts
    2,672
    Thanked: 0

    Arrow

    A sensor is more likely to be the culprit and not the TOD module,but the sensors are bit $$$$ not sure how much though.
    Dakar was just the begining.

  3. #3
    Member Since
    Nov 2004
    Location
    1999 Ex-Ebony..Fully Line-X'd ..0189...THE "ORW".....matching Line-X'd Trailer made from a written off 2001 Ebony.
    Posts
    4,403
    Thanked: 14
    Did you check tire pressure....and are you running equal tread tires?

    Jo
    VX.info...PLEASE SUPPORT THIS SITE WITH YOUR VOLUNTARY $20 DONATION...
    Absolutely the best $20 you'll spend per year on your VX.


    ~ ~ > OFF ROAD WHORE <~ ~
    [SIGPIC][/SIGPIC]

  4. #4
    Member Since
    Feb 2007
    Location
    2000 Proton VX - 0776
    Posts
    9,258
    Thanked: 0
    IIRC some of the cables under the VX run too close to the exhaust. Before paying for anything to be replaced, open every connector you can find under the vehicle, clean and lubricate. After all that, disconnect your battery for 30 min.
    [SIGPIC][/SIGPIC]

    Put a smiley after you say that Bub.

  5. #5
    Member Since
    Jun 2007
    Location
    2001, Proton
    Posts
    3,299
    Thanked: 0

    Twice

    I have had flashing TOD both times just sensors.
    "Take it up with my butt, cuz he's the only one that gives a crap"

    Carter Pewterschmidt

  6. #6
    Member Since
    Oct 2010
    Location
    '01, Foxfire Red, 0260
    Posts
    3
    Thanked: 0

    Tod Light Flashing

    Appreciate the help. Actually, the mechanic found the voltage output from the sensors ok. I took it back today, as they seemed eager to solve this. They suspect a short, as I think was mentioned by others on this board.
    Will keep you posted.

    Tires? Hmm...I run TOYO low profile 285 x 50 x 18, and one does show unusual inside tread wear. This should be interesting.

  7. #7
    Member Since
    Dec 2008
    Location
    Former owner 2001, Foxfire Red, #0663
    Posts
    7,311
    Thanked: 33
    Quote Originally Posted by Dobe View Post
    Tires? Hmm...I run TOYO low profile 285 x 50 x 18, and one does show unusual inside tread wear. This should be interesting.
    Not sure you knew what Jo was referring to about the tires...
    Sometimes if all 4 tires aren't pretty "equal" in all these terms: brand, size, model, air pressure & wear, the TOD system will often make severe clunking noises. Goes away when all 4 are pretty much equal.
    ***Some people have had this problem and some have not under same circumstances...so just thought I'd mention it as a possibility.
    VX KAT
    ....the adventure BEGINS ANEW! ...2015......
    Remember that life is not measured in the breaths you take, but rather in the moments that take your breath away.

  8. #8
    Member Since
    Nov 2004
    Location
    1999 Ex-Ebony..Fully Line-X'd ..0189...THE "ORW".....matching Line-X'd Trailer made from a written off 2001 Ebony.
    Posts
    4,403
    Thanked: 14
    Sort of Kat...

    Quote Originally Posted by VX KAT View Post
    Not sure you knew what Jo was referring to about the tires...
    Sometimes if all 4 tires aren't pretty "equal" in all these terms: brand, size, model, air pressure & wear, the TOD system will often make severe clunking noises. Goes away when all 4 are pretty much equal.
    ***Some people have had this problem and some have not under same circumstances...so just thought I'd mention it as a possibility.
    ...I've never had clunking.

    But you can throw a TOD check light if tire pressure/ tread amount are not equal..
    In other words, a variation in rolling diameters can mess with the TOD.

    jo

Similar Threads

  1. TOD Check Light Flashing
    By Axelivan in forum VX Troubleshooting...
    Replies: 10
    Last Post: 10/18/2013, 07:41 PM
  2. check toc light flashing red
    By Lightfx in forum VX Troubleshooting...
    Replies: 2
    Last Post: 04/24/2011, 06:52 PM
  3. TOD check light flashing
    By Diogenes in forum VX Troubleshooting...
    Replies: 8
    Last Post: 07/03/2007, 02:14 AM
  4. TOD light flashing
    By VXFTW in forum VX Talk...
    Replies: 11
    Last Post: 08/16/2006, 01:02 PM
  5. TOD check light flashing?
    By tooldini in forum VX Troubleshooting...
    Replies: 3
    Last Post: 07/30/2006, 10:21 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails