OK, that makes sense...Originally Posted by VXorado
Bravo, very astute. I was wondering if anyone would notice that.
I purchased the ebay special ball joint kit when I was doing my diff drop work earlier this year and found that they sent me the wrong kit because the lower BJs were shorter than the ones needed for a VX. I then ordered a higher quality set of lower BJs & kept the ebay uppers. When installing the uppers I noticed the cotter pin was too low to lock the castle nut, so being anxious to get the VX on the road I used some thread lock to secure the nut & decided to replace the uppers at another time.
I recently notice I have too much positive camber which must be from the upper balljoints as I didn't have any problems with camber prior to their install. I'll actually be installing new uppers this week & then taking the VX for an alignment since I just adjusted the torsion bar lift.
Just didn't want no bad ju-ju happening to you or your VX because of a possible oversight.
Reply With Quote