Page 1 of 2 1 2 LastLast
Results 1 to 15 of 22

Thread: High Idle suddenly =/

  1. #1
    Member Since
    Jul 2011
    Location
    2000 Proton Yellow #0586 CROSSCHECK
    Posts
    288
    Thanked: 0

    High Idle suddenly =/

    Leaving work and notice that my car idles around 1500 when in drive. I bumped in into Neutral and after a second or two the rpm shot up to almost 2500 steady. No, the throttle cable isn't stuck. Never noticed this before like 10 minutes ago. And yes, I'm killing the search function lol.
    "Therefore we conclude that a man is justified by faith without the deeds of the law. -Romans 3:28

  2. #2
    Member Since
    Jul 2003
    Location
    '01 Ebony #0939
    Posts
    2,142
    Thanked: 5
    Was the floor mat possibly up against the gas pedal? This issue has popped up with a few members here (it even happened to me once...never again though), and it's been described as intermittent at best. Not sure if there's really an answer to this one.

  3. #3
    Member Since
    Feb 2010
    Location
    2001,Kaiser,1130
    Posts
    346
    Thanked: 0
    This does sound A LOT like a transmission problem, especially if the engine flux idle sensor/capacitor thats inside the MRF is leaking. Have you had any recent work done? The MRF-usion bolt is behind the flexplate mounting bolts and can be damaged when the tranny is serviced??

    Mine did this last winter.. One time, RPMS go to 2500 after putting the car into park. The issue resolved itself and never happened again.

  4. #4
    Member Since
    Jul 2011
    Location
    2000 Proton Yellow #0586 CROSSCHECK
    Posts
    288
    Thanked: 0
    Hmmm. No. But I remember reading something on here once about remote starting the VX giving it issues and having to turn it off and restart it. I remote start my car each morning, but it has time to warm up. Today I remote started it from like 10 feet away and got right in and it did it immediately. It didn't happen once I restarted the car. Hmmm.

  5. #5
    Member Since
    Jul 2003
    Location
    '01 Ebony #0939
    Posts
    2,142
    Thanked: 5
    On second thought, I think the floormat issue was related to a Toyota Tacoma I used to have. Toyota had even incorporated hooks into the floorboard carpeting that went through a hole in the floormat to keep it from shifting too far forward.

    On VX's, the main possibility that's usually popped up is the drivers' right foot hitting the brake pedal and gas pedal at the same time because they're so close together, especially if aftermarket pedal covers have been installed.

  6. #6
    Member Since
    Feb 2006
    Location
    2001,Kaiser Silver, VX, 0563
    Posts
    4,767
    Thanked: 0
    Fuel pressure regulator caused all sorts of idle problems on my vx. some days it would idle at 2k rpms others it would stall out right away.. Seemed to be dependant on the engines temp when started and how recently the vx was driven.. After 5 minutes of driving it would return back to normal


    "Engineers believe if it ain't broke, it doesn't have enough features yet"

  7. #7
    Member Since
    Jun 2009
    Location
    2000, Kaiser, #0016
    Posts
    645
    Thanked: 0
    Tons of reasons for this to happen, and it is very common. Some causes are mundane, some are very esoteric. All I can say is do a search for "high idle" and be prepared to swap in some parts.

  8. #8
    Member Since
    Jul 2011
    Location
    2000 Proton Yellow #0586 CROSSCHECK
    Posts
    288
    Thanked: 0
    Was the fuel pressure regulator expensive or hard to replace? I'm not sure of the location of that part...

  9. #9
    Member Since
    Oct 2006
    Location
    01 Green Dragon 00291
    Posts
    255
    Thanked: 0
    Poor contact within the battery terminals or cables can cause erratic idle/high idle.

  10. #10
    Member Since
    Jun 2009
    Location
    2000, Kaiser, #0016
    Posts
    645
    Thanked: 0
    Quote Originally Posted by Breezy View Post
    Was the fuel pressure regulator expensive or hard to replace? I'm not sure of the location of that part...
    FPR is more expensive and harder to replace than many of the first tier "fixes".

    I'd call first tier somthing like clean the mass airflow sensor, replace the idle air control valve, clean or replace the throttle position sensor, same with EGR and PCV valves. Then move on to the FPR.

    If you can search the forum you would have seen all these suggestions many many times.

  11. #11
    Member Since
    Aug 2005
    Location
    1999, silver, 0887
    Posts
    1,408
    Thanked: 3
    Are you getting a check engine light and code? I had this problem recently and it turned out to be the idle-air regulator motor/valve asembly. $47.00 to replace.

  12. #12
    Member Since
    Jun 2009
    Location
    2000, Kaiser, #0016
    Posts
    645
    Thanked: 0
    Quote Originally Posted by blacksambo View Post
    Are you getting a check engine light and code? I had this problem recently and it turned out to be the idle-air regulator motor/valve asembly. $47.00 to replace.
    I think that's the air idle control valve or AIC. Very easy to replace and yeah about $45 at <insert local auto parts place here>.

  13. #13
    Member Since
    Jun 2009
    Location
    2000, Kaiser, #0016
    Posts
    645
    Thanked: 0
    Quote Originally Posted by atilla_the_fun View Post
    This does sound A LOT like a transmission problem, especially if the engine flux idle sensor/capacitor thats inside the MRF is leaking. Have you had any recent work done? The MRF-usion bolt is behind the flexplate mounting bolts and can be damaged when the tranny is serviced??

    Mine did this last winter.. One time, RPMS go to 2500 after putting the car into park. The issue resolved itself and never happened again.
    Shenanigans.

  14. #14
    Member Since
    Jul 2011
    Location
    2000 Proton Yellow #0586 CROSSCHECK
    Posts
    288
    Thanked: 0
    You're right Grif, I didn't look close enough.

    http://vehicross.info/forums/showthr...ight=high+idle

    I will go through these ideas and see how dirty things are, clean them, and replace them if I need to. I didn't see though the location of the IAC or PCV. Are they easily accessible from the engine bay? I'm googled for images, but it didn't show me locations.

  15. #15
    Member Since
    Dec 2008
    Location
    Former owner 2001, Foxfire Red, #0663
    Posts
    7,311
    Thanked: 33
    Quote Originally Posted by Breezy View Post
    You're right Grif, I didn't look close enough.

    http://vehicross.info/forums/showthr...ight=high+idle

    I will go through these ideas and see how dirty things are, clean them, and replace them if I need to. I didn't see though the location of the IAC or PCV. Are they easily accessible from the engine bay? I'm googled for images, but it didn't show me locations.
    PCV is right under plastic engine cover, driver's side, front. See that square part sticking out, it's right under that.
    VX KAT
    ....the adventure BEGINS ANEW! ...2015......
    Remember that life is not measured in the breaths you take, but rather in the moments that take your breath away.

Similar Threads

  1. fan noise & high idle
    By Baldwin in forum VX Talk...
    Replies: 4
    Last Post: 11/29/2012, 09:28 PM
  2. High idle/ high power steering pressure?
    By Rene M in forum VX Troubleshooting...
    Replies: 1
    Last Post: 09/22/2007, 03:21 PM
  3. High idle question
    By zadam123 in forum VX Troubleshooting...
    Replies: 15
    Last Post: 01/18/2007, 05:14 PM
  4. High/Low Idle at start up
    By Ruflyf in forum VX Troubleshooting...
    Replies: 1
    Last Post: 03/19/2006, 06:20 AM
  5. RPM to high at idle
    By ThunderChicken in forum VX Troubleshooting...
    Replies: 6
    Last Post: 09/23/2004, 11:09 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails