Feeling better and got a bit more done.

Completed pedals and interior...



I took my dremel and opened up the stock console some to accommodate the shift pattern. I am still trying to find a shift boot for this...



I took the connectors for the auto and taped them to the harness. Here is the harness ready to be installed...



Here is where all the majic happens. I am having a connector sent to me and will make a harness for the clutch switch, backup light switch, and hopefully cruise...



I ran the breather tube for the transfer case up into the engine compartment...



The big challenge is getting the wires run and connected to the correct O2 sensor. Another challenge is keeping wires away from the hot exhaust parts.