Cranking the torsion bars...
Hey everybody, stupid question....but I have not done this and could not find the answer in these threads. I was going to crank my torque bars, I found the Bolt to turn but have no idea which way to turn it to go up ( as im not too strong , I dont wish to do extra work by doing it both ways to find out ). I also noticed that that on the passengers side, the screw which sticks out opposite of the bolt to crank has about 1" 1/4 sticking out as opposed to the drivers side which has a little over 1/2" sticking out. Both sides seem even and I could only assume that the previous owner might have cranked one side to compensate for the suspension being bad on one side, does this seem like an accurate hypothesis? Thanks in advance to your replies.
Reply With Quote