Page 1 of 2 1 2 LastLast
Results 1 to 15 of 19

Thread: Major Transmission malfunction! Was fine, now barely made it home 2 miles!

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Member Since
    Feb 2007
    Location
    1999,silver,vehicross,1891
    Posts
    186
    Thanked: 0

    Unhappy Major Transmission malfunction! Was fine, now barely made it home 2 miles!

    Wow, I've doctored my VX all these years, all of a sudden this evening, transmission is slipping, big time, I barely made it home at 20 miles per hour just 2 miles home; , I could not get the car to go faster; by the time I got home the transmission check light was blinking, I've never seen that light before; I flushed and filled last year, but not this year, gonna check fluid level in the morning; I barely made it up my driveway and it's nearly flat! I could smell a burnt smell when I got outta the car. I have had no leaks so I never really check fluid level but it was perfect last year and I don't drive it long distances; my regular scanner didn't show any codes besides an evaporator clog code I get regularly; I guess I need a different scanner to pull tranny codes? Why would I suddenly lose all tork!!!! Holy Cow! My poor VX! Help!

  2. #2
    Member Since
    Feb 2009
    Location
    1999,silver, 1516
    Posts
    905
    Thanked: 0
    Sounds like it was low on fluid. You might not have done yourself any favors driving it home like that tho. I hope it isn't serious. Best of luck.

  3. #3
    Member Since
    Feb 2007
    Location
    1999,silver,vehicross,1891
    Posts
    186
    Thanked: 0
    Getting it inside now to check; did some reading on here; it's never leaked a drop, don't know where fluid could have gone; I was very careful when I changed fluid last year, it's never given me any trouble, it was a shocking 5 minutes, holy cow, problebly gonna drop the pan and see what metal accumulation I have; air tools should make quick work of it

  4. #4
    Member Since
    Jan 2005
    Location
    2001, Ebony Black, 1153
    Posts
    2,264
    Thanked: 2
    I also had no transmission problems until I had the Isuzu dealer change my tranny fluid, 1 month later my tranny was fried, I too noticed no leaking and I always park in garage. They had forgotten to go through all the gears and warmup the tranny to the correct temperature while filling the tranny and it was just a little low, but just enough to cause issues. Also too much fluid can also be bad.

  5. #5
    Member Since
    Jul 2009
    Location
    '01, Proton Yellow, 1028. '01, Gunmetal Metallic, 1033.
    Posts
    1,226
    Thanked: 0
    Somehow I doubt that your tranny was low enough on fluid to have caused your problem, if you as thorough as you say, you should have noticed a leak as a spot in your driveway or on your garage floor. Also, if it were a blown trans cooler line you would have smelled hot trans fluid as it thoroughly lubricated the underside of you truck, it's a distinctive smell. I suspect the final drive clutch pack just "let go". Lots-o-miles or hard driving has a way of eventually wearing things out. Too much fluid will blow a seal and you would definetly have noticed that, sometimes it just leaks out past the seal but not actually "blow" it. Whatever you find, I wish you luck, but I suspect a tranny rebuild is in your future...
    Vixer Fixer

  6. #6
    Member Since
    Feb 2007
    Location
    1999,silver,vehicross,1891
    Posts
    186
    Thanked: 0

    looks bad; Tropper II 4L30E mate perfectly to VX's??

    nearly no fluid came outta drain plug; what did, smelled terrible and was burned; I immeadiately noticed a mess of ATF fluid all over the front end; looks like intercooler blew; no leaks around lines that I have disconnected and previously drained, all of if came from above; gonna inspect closer in the morning;; I guess I will learn more from what i find inside the pans when I drop them in the morning; perhaps lots of metal; I fear tranny is toast; There are a dozen Isuzu Tropper 2 - 4L30E tranny's available, some under 100K and alot over 100K; any mating problems? Did Troppers not have dip sticks either?

  7. #7
    Member Since
    Jul 2009
    Location
    '01, Proton Yellow, 1028. '01, Gunmetal Metallic, 1033.
    Posts
    1,226
    Thanked: 0
    Too bad you drove it home, if you had caught that when it blew and immediately parked it, you probably would have saved it. It is most likely toast. In rare instances you can refill and still have a serviceable trans but it's life will have been shortened dramatically. Pull the pan and be prepared for the worst, it won't be pretty. As to what transmissions will fit from other Isuzus or Hondas or GMs, I can't say, but there are others on here that can and I'm sure they will. Best of luck!

  8. #8
    Member Since
    Apr 2008
    Location
    2000 Foxfire Red Mica, 0555 (RIP) & 0717
    Posts
    6,229
    Thanked: 3
    I for sure wouldn't buy a used transmission with 100K+ miles on it, you're just begging for it to go bad in a year or two also. I was quoted around $3400 installed for a new Jasper transmission or $2200 for a rebuild of my existing transmission. For that price (or less if you do the work) you could do a 5-speed swap and get a transmission that isn't even supposed to be serviced until 150K miles. Good reading for you:

    VT Maverick's 5-Speed Swap

  9. #9
    Member Since
    Feb 2007
    Location
    1999,silver,vehicross,1891
    Posts
    186
    Thanked: 0
    I'm in the Cincinnati area; the 4L30E is a very common General Motors transmission; I was surprised there; about a dozen of these at various salvage yards around me; $250 to $500; they all give some kind of warranty, but no labor of course so I'm rolling the bones; I really don't want to swap in non-OEM parts, from Fiat, Bertone, Nissan to my Isuzu, I keep them stock. if I could get a rebuild for $1000 I would jump on it; still haven't dropped main pan, intercooler still leaking fluid 2 days after shut down; messy; trying to figure out how to support "transfer case" properly to drop crossmember, I can't remember how I did it before; getting old I guess!

  10. #10
    Member Since
    Jul 2009
    Location
    '01, Proton Yellow, 1028. '01, Gunmetal Metallic, 1033.
    Posts
    1,226
    Thanked: 0
    You can use a scissor jack, a floor jack, a bottle jack, any jack and jack it up just enough to take the weight off the crossmember and unbolt it from the frame and trans tailhousing, dropping it out of the way.

  11. #11
    Member Since
    Feb 2007
    Location
    1999,silver,vehicross,1891
    Posts
    186
    Thanked: 0
    Scott, thanks, I actually used 4 truck stands, and used my 2 floor jacks; wanted to be safe; I used one jack at the front of the car at the skid plate, and my 2nd jack to lift the transfer case; I took the skid plate off the crossmember to reveal the lower transmission mount bolts cause I noticed the space created when I supported the transmission; so I took the crossmember skid plate off and unbolted the lower tranmission mounting bolts that gave me about 2 more inchs of space between the cross member and the rear most transmission pan bolts, a flexible 10mm head made them easy work; got all the pans off; I have obviously never done this before, I had my shop to it in 2007-08, then I did a fluid, small pan and intercooler drain/fill between now and then; this was a hard day; VERY LITTLE METAL IN MY PANS; NO CHUNKS! MAGNET HAD NORMAL AMOUNT OF residue on it as I have seen in my Nissan and Buick pans when I've done those pans/filters; alot easier I must say

  12. #12
    Member Since
    Nov 2009
    Location
    2001Proton 1432, ex 2001 Dragon Green Mica 0168 (RIP May 2017)
    Posts
    3,590
    Thanked: 31
    You did make sure that you ran through all the gears, got up to temp, and rechecked the fluid level right?

    This is an often overlooked step that can cause problems later if not done correctly.
    Live, Love, Forgive and Never Give Up

  13. #13
    Member Since
    Feb 2007
    Location
    1999,silver,vehicross,1891
    Posts
    186
    Thanked: 0

    Smile hoping for the best!

    Quote Originally Posted by Mile High VX View Post
    You did make sure that you ran through all the gears, got up to temp, and rechecked the fluid level right?

    This is an often overlooked step that can cause problems later if not done correctly.
    YEP, I followed a published procedure and an illustrated one on here, "TriAtheletes" I think; gonna put my pans back on in the morning after driping all nite, blow out the intercooler with compressed air and put a gallon of ATF III in it; my written record says thats how much it took last time; cycle, test drive, and may dump it again right away and fill, fluid is cheap, tranny isn't; don't think I'm going to start the car up and cycle gears with pans off; since it's been sitting a week, I am thinking most ATF has dripped out, still dripping now and what is dripping is normal color, normal smell, what was in my pan, was black nasty! Keeping my fingers crossed that this GM transmission is over-engineered to with stand a few miles of abuse, else, I'll be swapping in a salvage yard tranny; dozens available locally since it's a common transmission, cheap, 30 to 90 day guarantees but $400 to swap in, fill and test, if fails, swap again, in the computer industry, we call it "SWAP TIL YA DROP!"

  14. #14
    Member Since
    Feb 2007
    Location
    1999,silver,vehicross,1891
    Posts
    186
    Thanked: 0

    Question Tranny Pan condition

    Well, the bottom of the pan was black; but no loose metal; the magnet had what I think is a typical amount of residue on it, no chunks; I think my intercooler (cheap to replace new under $100); let go, and that leaked out quarts of fluid and I didn't know it, my "check trans" light came on only the last 2 minutes of my drive home though the clutchs/drive engage was acting up for several miles atleast, I wish I would have just parked it; letting it all drip out; DOES ANYONE THINK THAT WITH ALL THE PANS DOWN AND THE INTERCOOLER DISCONNECTED THAT I SHOULD TURN ON ENGINE AND CYCLE THRU GEARS TO GET MORE FLUID OUT!?!??!!?

  15. #15
    Member Since
    Jul 2009
    Location
    '01, Proton Yellow, 1028. '01, Gunmetal Metallic, 1033.
    Posts
    1,226
    Thanked: 0
    Don't run your trans dry, never run your trans dry, it can only cause problems as you have already discovered. You may get lucky and discover that with a simple filter change and refill with fresh fluid, that you still have a working transmission. Don't expect it to do you any favors though as you weren't very nice to it. If it does work however, you can do it a big favor and change the filter and fluid again in about a week to flush out the rest of the carnage you've left behind. Don't forget to follow the trans fill and check procedure every time you change or add fluid or you'll be running with an underfilled trans!

Similar Threads

  1. Drives fine without ABS module
    By DaveMcKenz in forum VX Troubleshooting...
    Replies: 3
    Last Post: 04/22/2017, 07:24 AM
  2. door locks barely working
    By vxcp in forum VX Troubleshooting...
    Replies: 3
    Last Post: 06/18/2014, 07:14 PM
  3. Home Made Space Craft
    By crotchrocket in forum Chit-Chat ...
    Replies: 3
    Last Post: 09/30/2010, 08:08 AM
  4. A fine day out….
    By CrnCnn in forum VX Talk...
    Replies: 58
    Last Post: 03/17/2008, 10:07 PM
  5. TOD Malfunction ?
    By maxw in forum VX Troubleshooting...
    Replies: 8
    Last Post: 02/14/2006, 08:01 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails