I had the last week off from work and was hoping to finish a few projects on the VX. Unfortunately, it's been in the single digit temps here and there's no way I can do the work in the garage that I was planning. I did manage to finish a couple small interior projects.

Steering Wheel

I did a trade with Mikemol that included my red/blk seats for a JDM steering wheel. The install was simple but required some wiring for the airbag which I was able to do without too much trouble. The JDM steering wheel was made by MOMO and is a bit smaller than the US steering wheel. Additionally, the horn is built into the steering wheel side grips instead of the airbag.









Gauges
I really wanted the reverse glow gauges that Kenny & Littlebeast installed but I believe they are discontinued for Isuzu models. After hours of research, I found similar gauges from a 90s Honda that looked to be the same size. Luckily, the gauges just required a little trimming to make them work. I still have a bit of work to do in the future to change the other gauges to blue.

While I had the gauges out of the VX, I removed the annoying ABS light and adjusted my speedo needle to correct MPH with bigger tires. I checked the speedo to my GPS yesterday and they read the exact same at 65 MPH.















Seats & Doors
In August, I got a set of grey/blk seats from a wreaked VX. I just needed to paint the door cards satin blk/gloss blk to match the new interior.



Installed pics of Gauges & Steering Wheel




The interior is coming together.