Page 2 of 2 FirstFirst 1 2
Results 16 to 24 of 24

Thread: Need help vx won't turn over

  1. #16
    Member Since
    Jun 2002
    Location
    1999, Ebony, VX, #1679
    Posts
    8,422
    Thanked: 3
    Look for loose connectors on either end, excessive corrosion. The corrosion can seep down the cable even if the terminals are clean...enough juice will get through for the smaller components (lights, stereo etc) to work but not enough to turn the starter. Happened to mine. Replaced cable (top portion...the lower portion ties into the wire harness) and has had no problems since.
    Billy Oliver
    15xIronman
    My Sponsors:
    Accelerate3Coaching
    TriSports.com (PM me for 1 time use 20% off code)

  2. #17
    Member Since
    Apr 2011
    Location
    99 Ebony, VX, #2007
    Posts
    76
    Thanked: 0
    Makes sence but why would disconnecting the battery work once but 30 mins later it not want to start again. It does sound like the starter relay is clicking but normally a bad connection or a weak battery will still lead to some noise from the starter. The earlier start sounded as strong as ever which also leads me away from a bad battery connection. At this point it's looking like I will have to get a tow. But knowing my luck it will start once in the morning and leave me stranded somewhere else

  3. #18
    Member Since
    Apr 2011
    Location
    99 Ebony, VX, #2007
    Posts
    76
    Thanked: 0

    Unhappy

    Well after trying to jump the truck thinking the 14.5 volts might help push past any corrosion in the cable I'm out of ideas and am getting it towed to a better location my garage.

  4. #19
    Member Since
    Aug 2012
    Location
    99 Ebony Vx's, 0054 & 1548
    Posts
    349
    Thanked: 0
    just thinking and typing....
    steering column switch? it controls the lock pin on the column. If it is not locking, it might not let the vx start. The Ignition lock switch (right) plugs into the Ignition switch control (left side in column) and it has wiring plug on it.
    trying to help....
    I haven't had any simular problems with the vx

    Life is better when you go Topless

  5. #20
    Member Since
    Apr 2011
    Location
    99 Ebony, VX, #2007
    Posts
    76
    Thanked: 0
    Well I got the wheel to lock. I had to turn it 1.5 turns but it locked. It's home now the toe truck driver managed to back it right into the garage so further application of the bfh can be done out of the cold

  6. #21
    Member Since
    Jul 2003
    Location
    '01 Ebony #0939
    Posts
    2,142
    Thanked: 5
    You might try removing and reseating the Starter Relay and the Starter Cut Relay in the engine bay fuse box. Have you noticed any erratic illumination of the gear position indicator lights on your dash as this has been happening?

  7. #22
    Member Since
    Apr 2011
    Location
    99 Ebony, VX, #2007
    Posts
    76
    Thanked: 0
    Nothing weird on the dash while attempting to start. Only weird light display is on the fifth turn from off to run. I get a loud beep from out side the truck and all the lights on the dash flash once

  8. #23
    Member Since
    Apr 2011
    Location
    99 Ebony, VX, #2007
    Posts
    76
    Thanked: 0
    Ok so small update, it is not the the security system or the park neutral switch. The starter relay itself is activating but havering no affect on the start. So nw Saturday after work I have to jump the selonoid to rule out a bad starter if that's good I'll have to trace wires.

  9. #24
    Member Since
    Apr 2011
    Location
    99 Ebony, VX, #2007
    Posts
    76
    Thanked: 0
    So finally figured it out. After making a small modification to the inner fender so I could get to the starter. All it took was a wiggle of the signal wire connector to the starter and she fired up. My guess is that it shook loose now all I have to do is secure it and hope it doesn't come loose on the trail this weekend

Similar Threads

  1. wipers do not turn off
    By disasterlady in forum VX Troubleshooting...
    Replies: 3
    Last Post: 11/11/2016, 08:16 AM
  2. Now it's my turn....
    By Gussie2000 in forum VX Troubleshooting...
    Replies: 7
    Last Post: 01/26/2012, 08:11 PM
  3. Key won't go into ignition or turn
    By kobie in forum VX Troubleshooting...
    Replies: 17
    Last Post: 06/29/2010, 11:41 PM
  4. Now it won't turn over
    By DK in forum VX Troubleshooting...
    Replies: 3
    Last Post: 05/16/2005, 11:11 PM
  5. turn off TOD?
    By marximus in forum VX Talk...
    Replies: 2
    Last Post: 12/31/2004, 06:33 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails