1/10 Scale VX RC-Crawler

[nfpgasmask]

Yeah, well, up top looks better than bolted to the tailgate!

Bart

[ZEUS]

Made some more progress this week. In one night (Wednesday) I had three issues develop. I was filling & sanding the roof rails & started noticing hairline fractures in each of them. Added some CA glue in between the cracks & some more filler & seem to be back on track. Then while I was using brake fluid on the body to remove the paint (read it was a viable option) I broke the rear spoiler in two. Glue & sanding was making the spoiler look great... and then it cracked in another spot! More glue, more sanding... it looks good again. Then because the brake fluid yielded poor results, I gave the body a good washing & tried using the graffiti remover that's for my vinyl fence. I think the brake fluid made the spoiler brittle & the graffiti remover made the body soft. I found a few spots where it looks like the plastic started to bubble! AGH! I gave it a good washing again really fast. So... instead I made the decision to sand the entire body... so far, it has taken several hours over three days... I'm using 80, 100, 120, 180, 220, & 320 grit sanding sponges & small hobby files.

This weeks progress:

Several passes of filler & sanding looks like this midway:


After another round of sanding, they look like this:



The body now looks like a VehiGHOST or VehiTRON - I have started using filler on the roof:


So here is how everything is for now:


I picked up some styrene & could start cutting out pieces in order to reshape portions of the body this week... but I am still adjusting some of the seam lines here & there too... I have a tough decision to make on that & will explain that in more detail later.