Super VXer
Ever since my Tranny was dropped and that cross member cut off to get it down my O2 and TOD sensor harness's have not been in their correct locations, I know you can't and don't want to run them around your cat, where do these connector blocks go? Here are some pics of that I'm talking about; THANKS ALL!
Super VXer
looked thru manual, still can't figure out how these harness's should be arranged; just double covered car up due to rain out in driveway for now
VXer
emailed ya some pics... hope they help out.
[SIGPIC][/SIGPIC]the 2nd mouse gets da cheese
Super VXer
If I'm not mistaken, (and I often am) the harness runs under the transfer case along the backside of the crossmember and there is a bracket that bolts to the topside of the crossmember close to the frame rail to hold the harness in place. The connectors tuck up insde the right frame rail. Did you reroute the harness over the transfer case? Regardless of the harness routing, you are missing that small bracket that secures it to the top of the crossmember.If it wasn't raining profusely at the moment, I would go out and crawl under mine to scope it out for you!
Vixer Fixer
VXer
bingo! great memory Scott.Originally Posted by Scott Larson
If I'm not mistaken, (and I often am) the harness runs under the transfer case along the backside of the crossmember and there is a bracket that bolts to the topside of the crossmember close to the frame rail to hold the harness in place. The connectors tuck up insde the right frame rail. Did you reroute the harness over the transfer case? Regardless of the harness routing, you are missing that small bracket that secures it to the top of the crossmember.
Posting Permissions
Reply With Quote