Results 1 to 15 of 15

Thread: Tire, Wheel and TOD Help Needed!!

  1. #1
    Member Since
    Dec 2003
    Location
    2000, Black, VehiCross, 0551
    Posts
    32
    Thanked: 0

    Tire, Wheel and TOD Help Needed!!

    I am a new member here and I was hoping someone may be able to help.
    I recently had an encounter with a curb in a snowstorm here in New Jersey. I blew out the right front tire and slightly bent the rim. Following are several pictures of the damage:







    I need help with the following:
    1. Can the rim be bent back into shape? A new rim is $499 through the dealer!!!!!
    2. Does anyone have a rim they can sell me?
    3. THe sidewall has a slash in it, thereby necessitating its replacement. I was going to buy a replacement tire (Yokohama AVS S/T 265/60/18) from Tire Rack. Is this the best option?
    4. Lastly, I drove approximately 80 miles at 45-50mph with the donut spare on the right front wheel. At about that point the TOD started to make some weird noises. They were sort of like groaning noises. I thought the smaller donut may have been the cause. I finished the drive home, another 20 miles, doing 20 mph with my flashers on to avoid the noises. What did I hear? Did I ruin the TOD, transmission or differential due to the smaller donut spare?


    Any help would be greatly appreciated. Please reply!!

    [This message has been edited by kpv (edited 12-15-2003).]

    [This message has been edited by kpv (edited 12-15-2003).]

  2. #2
    Member Since
    Dec 2003
    Location
    2000, Black, VehiCross, 0551
    Posts
    32
    Thanked: 0
    Spazz,
    My stock wheels are 18". I am surprised that yours are 16.

  3. #3
    Member Since
    Nov 2003
    Location
    2004 Frontier S/C formally '99 1174
    Posts
    279
    Thanked: 0
    Here's the deal:

    There are places out there that can fix a wheel, just check around at some local body shops to find out who they use and if they are reliable. This usually requires sending the wheel out to them for about 2 weeks and runs anywhere between $110 to $200 depending on the damage.

    Best option for the tire is to get a new one and place it on the rear so that the tread is the same on the 2 front tires. Once you drive your VX for awhile it will wear the new tire enough that it won't matter when you rotate your tires 6,000 mile later.

    Third option, buy a new set of aftermarket wheels with the tires already mounted (wheel/tire combo) from almost any internet wheel dealer. Cost anywhere between $1500 to $4500 depending upon what you want and how fast you want it.

    Good luck!!

    Oh yeah, lastly take off the spare on the front and put one of the rear wheels in its place. Drive and see if the noise is still there. If the noise persists remove your brake rotor and check the wheel bearings, the curb impact could've cracked one which would cause a grinding sound.
    Last edited by VX_PA : 12/15/2003 at 11:35 AM

  4. #4
    Member Since
    Dec 2003
    Location
    2000, Black, VehiCross, 0551
    Posts
    32
    Thanked: 0
    I ordered a replacement tire from TireRack. $160 delivered to my door.

    Ideally, I would like to find someone that has upgraded their wheels and is interested in selling one or two of their original wheels. Is anyone interested in this?

    Cracked bearing, huh? That does not sound like fun. I will have to research that further.

  5. #5
    Member Since
    Aug 2003
    Location
    2001 Kaiser #0894
    Posts
    132
    Thanked: 0
    KNOCK ON WOOD... bad bearings really aren't THAT big a deal. not saying you don't need it fixed, but i could think of worse you could have done smacking into the curb like that!
    Do they ever stop looking?

  6. #6
    Member Since
    Dec 2003
    Location
    2000, Black, VehiCross, 0551
    Posts
    32
    Thanked: 0
    Isn't there anyone out there that has a stock wheel they want to sell?
    If not, does anyone think mine can be repaired?

  7. #7
    Member Since
    Nov 2003
    Location
    2004 Frontier S/C formally '99 1174
    Posts
    279
    Thanked: 0
    Stock 18's sell fast around here. I told you already that your wheel can be repaired it's just going to take some research on your end. Call some local repair shops and get some names, it can be fixed.

  8. #8
    Member Since
    Dec 2002
    Location
    '01 Ironman
    Posts
    1,286
    Thanked: 0
    I had a rim that got a mark kinda similar to yours from offroading and it worked perfectly fine still. You might only need to replace the tire.
    2001 Ironman Daily Driver... 3.5" suspension lift (OME912 springs and 1" spring spacer), ball joint flip, 1.5" front diff. drop, 33"x12.5 TrXus MT, 16x10 Eagle Alloy rims, Interceptor, PV muffler, K&N air filter, Alpine Supercharger, Bilstein shocks, and some trimming.

    2000 Ironman Project LS-1 VX... very slow progress but someday....... ohhhhh someday......

  9. #9
    Member Since
    Jun 2002
    Location
    2001 Black, Black, and more Black
    Posts
    303
    Thanked: 0
    I would caution having the new tire on the rear. It's probably safer, but not as good for the limited slip.

    Also keep in mind that if your other tires are sufficiently worn, TOD might not like the new tire much either.

    mmm...locking hubs. No worries about the size of the spare on the front.

    -Daver
    -Daver

  10. #10
    Member Since
    Sep 2003
    Location
    2001,Ebony Black,
    Posts
    39
    Thanked: 0
    I have my stock 18"s that I might be interested in parting with they are in good shape with no major blems just normal wear. I would sell them for 200 a piece plus shipping. If three other people are interested.

  11. #11
    Member Since
    Jan 2003
    Location
    99 ebony 9532
    Posts
    50
    Thanked: 0
    kpv: You mighy want to try www.carparts.com....there might be a salvage yard close to you .that might have one. good luck and welcome aboard!! VX FIX Fred
    YOU CANT PUT A PRICE ON FUN !!

  12. #12
    Member Since
    Jan 2003
    Location
    99 ebony 9532
    Posts
    50
    Thanked: 0
    kpv; typed in wrong site address. sorry ...the correct one is .....www.car-part.com

  13. #13
    Member Since
    Sep 2003
    Location
    2001,Ebony Black,
    Posts
    39
    Thanked: 0
    Hey VX FIX I am in Ohio too. I am in Mansfield. Maybe we could get together some time.... Joe

  14. #14
    Member Since
    Jun 2002
    Location
    Former owner of '01 Ebony #0739
    Posts
    1,579
    Thanked: 5
    If you are looking for a cheap 18" replacement, check my post...

    http://www.vehicross.info/forums/sho...&threadid=2713
    The only thing we have to fear is fear itself... and zombies.


    My VehiCROSS

  15. #15
    Member Since
    Jan 2003
    Location
    99 ebony 9532
    Posts
    50
    Thanked: 0
    hey joesvx..sounds good to me ..always looking for reason to drive my vx . I have lots of time from end of Dec... to first part of March. just e-mail me .... Fred

Similar Threads

  1. Replies: 20
    Last Post: 04/02/2011, 12:01 AM
  2. needed a tire opinion?
    By pbkid in forum VX Modifications...
    Replies: 30
    Last Post: 03/28/2008, 07:59 PM
  3. Tire and wheel size advice needed
    By BritVX in forum VX Modifications...
    Replies: 4
    Last Post: 09/23/2007, 07:48 AM
  4. Yet another tire & wheel Q
    By skater in forum VX Talk...
    Replies: 8
    Last Post: 05/12/2007, 03:08 PM
  5. Wheel advice needed !!!!!!!!
    By thedutchguy in forum VX Talk...
    Replies: 20
    Last Post: 04/21/2006, 02:23 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails