Results 1 to 14 of 14

Thread: High Idel problem

  1. #1
    Member Since
    Jun 2002
    Location
    1999 silver 1346
    Posts
    505
    Thanked: 0

    High Idel problem

    Lately every once in a while I have a high idle and even when i put it in gear it feels like the car wants to take off. When this happens i put it in nutral and im reving like 3500 RPM when a normal idel is just under 1000., any ideas what could cause this?

    PS I tried the tap the gas routine and it still revs high and will go down eventually on its own.

    adam

  2. #2
    Member Since
    Jun 2002
    Location
    1999 silver 1346
    Posts
    505
    Thanked: 0
    I have the calmini air filter. I have it for almost a year now.

    adam

  3. #3
    Member Since
    Dec 2002
    Location
    '01 Ironman
    Posts
    1,286
    Thanked: 0
    I know this has came up before, if you do some searching on fluxuating idle or just idle you should come up with the answer. From what I remember I think you need to clean a senser in the intake? Not sure.... its on this site somewhere
    2001 Ironman Daily Driver... 3.5" suspension lift (OME912 springs and 1" spring spacer), ball joint flip, 1.5" front diff. drop, 33"x12.5 TrXus MT, 16x10 Eagle Alloy rims, Interceptor, PV muffler, K&N air filter, Alpine Supercharger, Bilstein shocks, and some trimming.

    2000 Ironman Project LS-1 VX... very slow progress but someday....... ohhhhh someday......

  4. #4
    Member Since
    Jun 2002
    Location
    1999, ASTRAL
    Posts
    734
    Thanked: 0

    Lightbulb Could be your PCV...

    Change it and see if the problem goes away.
    NAVIGATOR

  5. #5
    Member Since
    Jun 2002
    Location
    1999 silver 1346
    Posts
    505
    Thanked: 0
    would that porblem stay if the filter was dirty cause it only happens onece in a while?

    adam

  6. #6
    Member Since
    Jun 2002
    Location
    '99 Ebony Black VX, 0339
    Posts
    2,073
    Thanked: 0
    Common problem with intake gaskets, idle control valve as well as the power steering pressure switch.

  7. #7
    Member Since
    Sep 2002
    Location
    2001, Proton Yellow, Vehicross, #0170
    Posts
    62
    Thanked: 0
    Yep. Mine did the same thing for a while. Then the check engine light came on. Took it to the dealer and it ended up being the intake gaskets.

  8. #8
    Member Since
    Jun 2002
    Location
    '01 Proton #
    Posts
    108
    Thanked: 0
    Clean the inside of your throttle-body with a WD-40 soaked rag. You need to take off the air intake duct and unbolt the throttle-body (4 bolts) and also disconnect your throttle and cruise control cables. Then, just thoroughly wipe clean both interior surfaces of the unit along with the throttle intake flap. That is all there is to it!

    Good Luck!
    Happy Flying!

    Randy

  9. #9
    Member Since
    Jun 2002
    Location
    00 00 00
    Posts
    1,627
    Thanked: 0

    Re: no start....then high Idle...

    Originally posted by SPAZZ
    ...I get out, open the gas lid, push that little vent hole, and then start it again and whoalllaaahhhh...it starts right up.
    Spazz, my man... sometimes they just like it that way.

  10. #10
    Member Since
    Sep 2002
    Location
    '01 EBONY 1330 r.i.p. now '01 PROTON 0987
    Posts
    799
    Thanked: 0
    When you try to start it several times and it dies, go back to the tailpipe and take a good whiff. Does it smell like raw fuel or no fuel?


    A new gas cap, filter + pcv would be cheap even if it didn't fix it. Can you swap caps with somebody temporarily?

    Without trying to sound too erotic, I don't think fingering the hole is doing anything. At least not for the VX.

    More likely the removing of the gas cap.

    Another option when it doesn't start right off, might be to turn the key to on, not start. Get a rag and go under the hood and depress the schrader valve on the fuel rail, remembering that the fuel should be under pressure, 30- 40lbs. Does fuel come out?

    When you say you have to hold the pedal down to get it to start, do you mean hold it at wide open throttle (clear flood) position or just hold it slightly more open than idle position?

  11. #11
    Member Since
    Sep 2002
    Location
    '01 EBONY 1330 r.i.p. now '01 PROTON 0987
    Posts
    799
    Thanked: 0
    That's what I was thinking. No fuel. Now to figure out why . And why is it intermittant? Pump? Filter? Pres. regulator. Electrical? Fuel pump relay?? Put the rag over the schrader valve when you test it. The fuel will want to spray, if there's any pressure.

    Tone , where are those fuel pressure gauge kits????????

  12. #12
    Member Since
    Oct 2003
    Location
    99', Astral Silver, 0430
    Posts
    20
    Thanked: 0
    I had the high idle problem, as well as the dipping idle. I tried cleaning the MAF sensor, the Idle Air Control Valve, timing belt, valve timing (it was time 100,000 miles), etc. I finally threw a code for the idle air control system, replaced the valve and all has been well.

  13. #13
    Member Since
    May 2003
    Location
    1999,black,vehicross 1724
    Posts
    20
    Thanked: 0
    I have same problems like you guys.

    I'll see a mechanic on Monday.

    Let's see what he will talk about.

  14. #14
    Member Since
    Sep 2002
    Location
    '01 EBONY 1330 r.i.p. now '01 PROTON 0987
    Posts
    799
    Thanked: 0
    Why doesn't Isuzu re-design or revise the 5 piece (per side, if you count the brass rivets) intake gaskets with a plastic that wont crack, or even a one piece design?

Similar Threads

  1. Another high idle problem
    By RAZ in forum VX Troubleshooting...
    Replies: 20
    Last Post: 07/13/2011, 11:59 AM
  2. Driving problem fixed/TOD problem realized
    By mattlewis9333 in forum VX Troubleshooting...
    Replies: 4
    Last Post: 02/26/2010, 05:57 AM
  3. High idle/ high power steering pressure?
    By Rene M in forum VX Troubleshooting...
    Replies: 1
    Last Post: 09/22/2007, 03:21 PM
  4. Replies: 7
    Last Post: 08/03/2007, 05:33 AM
  5. VX won't idel or idles fast?
    By tooldini in forum VX Troubleshooting...
    Replies: 6
    Last Post: 04/12/2003, 12:48 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails