OK I did a bit of research on the sub and amp I'm considering here's the specs: Both are Sony Xplod

SUB;
10" subwoofer
600w max
single 4 layer 4 ohm voice coil
rated imput power=150w
impedance=4ohms
sensitivity=88db/w/m
freq. response=25-2,800Hz
mass approximately 3.6kg
7lbs 15oz per speaker
gold plated terminals

AMP;
35w X 2rmp @ 4 ohms (100w X 2 max.)
80w X 1rms @ 4 ohms (222w X 1 max.)
low pass filter (80Hz, 12dB / oct.)
high level speaker input
dual mode capability
MOSFET power supply
6v input
gold plated terminals

Now the questions are; will these two work with one another and how will they sound? And, can the amp be wired through the high level speaker inputs to the rear speakers? If so can the rear speakers still work or do their wires have to be dedicated to the amp?
And, finally...If you had these components to hook up to your VX how would you do it?
Oh and would you use the blue ant. wire behind the oem HU to connect to the remote turn on? or would you use something else?

Thanks for all your help and wisdom...carl